I’m looking for a carpenter or cabinet maker to adjust the dishwasher cavity in my kitchen. The dishwasher needs a 600mm wide cavity. The opening is fine at the front, but it narrows towards the back to around 595mm, so the dishwasher won’t slide all the way in. Either the cavity was built slightly tapered or the side panels have swelled over time. The cabinets are melamine. What I need: * Trim the side panel(s) so the cavity is at least 600mm wide all the way to the back * Seal any exposed raw edges so they don’t absorb moisture * Make sure the cabinets either side are still solid and the drawers/doors still work properly If you think there’s a better fix than trimming the panels, I’m open to suggestions.