Front door, timber, opens inward. Current lock is a Gainsborough Trilock 8951ANG (combined lever and deadbolt): 54mm face hole, 60mm backset, 22mm edge hole, four 10mm screw holes near the corners of the plate. Photos attached. I'm supplying an Aqara U400 smart deadbolt (54mm bore, 60/70mm backset, 35-55mm door thickness). Physical install only, I'll do the app setup. I'd like your recommendation and a price for each option you'd consider: OPTION A U400 in the existing Trilock hole, plus a new passage lever set (no lock, latch only) in a new 54mm hole about 120-140mm below it. I can supply the lever set if you recommend this. OPTION B Keep the Trilock as the handle and install the U400 in a new hole above it (about 200-210mm centre to centre). OPTION C U400 in the existing hole, plus a back-to-back pull handle and magnetic catches instead of a latch. Please also tell me: 1. How you'd handle the old Trilock holes and plate outline that won't be covered by the U400 (the top two screw holes are likely to show on the outside). Do you fill and paint, use a cover plate, or something else? Is that included in your price? 2. Whether the 22mm edge hole needs widening and the frame needs new strike plates, and whether that's included. 3. Whether you'll check the door alignment so the deadbolt throws cleanly and auto-lock works. Must have smart deadbolt installation experience and bring your own tools (hole saws, chisels). A clean, neat finish is important since this is the front door.
0 new tasks