Looking for an experienced carpenter or carpenter/plasterer to build and finish a straight internal timber stud partition wall with an access door inside a single lock-up garage, plus install a smart mortise lock onto the main front entry door while on site. All existing garage walls and the ceiling are already plastered, so the wall work is solely for the new dividing wall and tying it in neatly. Specifications & Scope of Works: Partition Wall Framing: 3.1m wide spanning across the garage, positioned approx. 1.1m behind the existing roller door (standard ceiling height approx. 2.4m–2.7m). Construct using 90x45 H2 treated pine studs (450mm or 600mm centres) secured to the concrete slab over a continuous polythene damp-proof course (DPC) strip, and fixed cleanly into the side walls and ceiling joists. Insulation: Supply and install acoustic/thermal insulation batts (R2.0 or R2.5) inside the stud cavity. Internal Shed Access Door: Frame an opening on the left-hand side of the new wall and supply/hang a standard 820mm x 2040mm solid-core door (swinging outward into the front storage bay), fitted with architraves, perimeter draught/weather seals, a door bottom sweep, and a keyed entrance lever set. Plasterboard, Cornice & Skirting: Sheet the internal room-facing side with 10mm plasterboard (and sheet or leave neat on the front storage-shed side), tape, three-coat flush, and sand ready for paint. Match and install standard cornice along the top (room side) to tie into the existing ceiling cornice, plus primed timber skirting along the bottom. Main Front Door Smart Lock: Remove existing front door lockset and install a customer-supplied Kogan SmarterHome Wi-Fi Fingerprint Video Smart Lock with Monitor (Type 5085 mortise lock body, 50mm backset, suits 35–80mm timber door), including chiseling the mortise pocket and aligning the strike plate.