Find a trusted local mechanic in Glen Waverley

Install an amplifier in a Toyota Prado 2007 120 series with an already upgraded head unit - all plug play connections. - Due date: Flexible

Need to remove my oil filter from my Lexus rx330 or at least loosen it so that I can remove it for my oil and filter change I have the car lifted on a jack so the filter is accessible from underneath the car. - Due date: Needs to be done on Sunday, 15 January 2023

I’ve just brought a head unit and fascia kit and need help installing it into my 2005 Honda CR-V - Due date: Before Sunday, 2 October 2022

I need my car serviced and brake pad front replaced HONDA JAZZ 2015 - Due date: Flexible

I purchased a replacement head unit from https://premiumheadunits.com/search?q=toyota+estima&type=product%2Carticle%2Cpage&options%5Bprefix%5D=last This came with the wiring harness(es) for the vehicle as well as a mic, DAB radio, and GPS. It did not however come with any information (other than how to use the menus on the head unit once up and running) or installation instructions. I uninstalled the original (Japanese) head unit, ran the wires for the DAB, mic, and GPS. Hooked up all the relevant connectors as seemed obvious to me, and inserted the new unit into the dash. There are no signs of life, so obviously have not installed correctly, which came as no surprise. If it had worked, that would have been the surprise. The place of purchase has phone support, but I don't know where to start. If you are familar with these (or similar) units and parallel import Toyota Estima vans, and are a good troubleshooter, then this might be opportunity for you. One key function from the original would be to work with the factory reversing camera. - Due date: Flexible

perform general mechanical work to 1975 Toyota Celica which has had a replacement engine fitted. Connect all plumbing and mechanical items to get ready for roadworthy. I have a Toyota workshop manual. - fasten engine mounts and gearbox mounts - fit tailshaft - connect water hoses to radiator and heater outlet - connect fuel line to engine - connect ignition wiring - connect clutch line - connect vacuum hoses - adjust accelerator cable - swap front brake calipers - bleed brakes - fit exhaust system - check everything - set up for roadworthy Due date: Flexible

New tow bar installation to Mazda3-Hatch (year2003) - Due date: Flexible

My clutch is completely shot and I need it replaced. If you've got tools and jacks I'd be more than happy to help out.

Fit an after market head unit to a 2013 Subaru Forster, connect an Led light bar with switch.

I need assistance with the installation of a JVC KW-M560BT head unit into my 2016 Honda Fit/Jazz. I have no tools or expertise to do the job. I currently have the head unit itself, a CHHO8C steering wheel control interface, APUNIPL2 steering wheel control patch lead and an FP8077 Facia (Pls see pictures from aerpro website for info). According to aerpro, I may or may not need extra harnesses, pls advise me if I do. I am about to make an order for the FP8077T facia harness (and other harness if needed), so I will want the job to be done once the items arrive. My car already has a rear camera installed so pls advice me if I need anything extra to connect that to the head unit. I work around Glen Waverly from Mon-Fri and finish at 6. If anyone is near there and can get the job done some time past 6, pls contact me cheers. I previously put this job up before but have been busy so didn't get time to post it up again. - Due date: Flexible

The car is not in very good condition (It still starts and drives but a wheel is missing) Need a mechanic with a jack to check the car. I need a full and detail report and a list of all the mechanical parts that need to be repaired and replaced. located in Glen Waverley VIC 3150

Car : 2012 Toyota Yaris Head Unit: Sony XAV-AX1000 Ambient Lighting: 3 x 1m El light strips, helpful if you are able to provide light strips too, want to install across dash and side doors - Due date: Flexible

I have a Honda Odyssey 2020 VTI-L, just want someone reliable to install a tow hitch for the car, need that for a bicycle rack. The tasker need to get the tow hitch as well - Due date: Flexible

Looking for a mechanic who has experience with early model 1995 Honda Civic. Work needing done is as follows: -Fit new gearbox and clutch kit -power steering rack replacement I will be providing all the parts so just need labour. Must be able to come on site I am not interested in getting it towed. - Due date: Flexible

For my Honda crv 2002 at glen waverly

** price low for quoting purpose only** Mitsubishi Outlander 2008 needing timing belt, water pump, repair to be done at my home, as it got towed here! Days & times extremely flexible as I wfh. Single mum budget 😂😂😂 so I am looking for competitive but good! Details as per autobarn Rego search. MITSUBISHI OUTLANDER VR, VR-X Auto ZG, ZH CW6W 12/2006~10/2012 4 Door SUV 4WD PETROL 3.0 litre, 6B31 V6 24v SOHC VVT MPFI {162KW}

Timing belt replacement to be done asap

Hi there, I am going to inspect a used car (a Citroen) and would like a qualified mechanic to check over it please. The car is in Glen Waverley, and if possible, I would love it inspected tonight

Toyota Kluger 2018 tow bar installation

Hi, I need a mechanic to inspect a car this evening 13/04/21 in Glen Waverley at 6pm.