Find professional lock installation in Melbourne

Smart locks installation. 1. Front Door - Replace deadbolt with Eufy S3 Max Video Smart Lock (I will supply) - Change the bottom lever so that it's non-lockable. 2. Garage Door (internal) - replace deadbolt with a smart lock or would consider mechanical keypad, but it needs to lock from both sides. I need assistance recommending a product for this. - replace lever as the current one is broken, with as similar as possible. Also need help selecting this. Photos attached. We are home most days, so I'm flexible on when this gets done.

I bought a Eufy C33 Smart Lever Lock for my house and want to swap over my current deadlock but I don’t have the right tools unfortunately. It needs a hole cut in the door that’s a minimum of 45mm diameter (the current hole is only 35mm) and it needs a 1 inch hole in the side of the door for the latch and another one on the door frame for the strike plate. If you have the tools to cut these holes for me and chisel out the rectangle for the strike plate and latch, please send an offer. I’d like to get this done today since I’ve already removed the old lock and don’t want to put it back on. Instructions are in the photos.

Need locksmith to replace our key door lock in the shop.

I need to add locks (with keys) to x2 double door cupboards. The locking mechanisms will need to be procured too as I don’t have any. Please see the attached images for one Of the cupboards outside and inside (the other cupboard is identical). Thank you!

We have the door on site. Needs to be cut down from 820mm to 720mm. Installed and lock installed to that door.

Need a bedroom door handle replaced. I have the replacement handle. Please see image to ensure you can do the job (the screws holding the door handle in place appear to be worn). The job involves removing the current door handle and installing the replacement one. That's it.

Nissan pulsar LX model 2000. Lost the door keys, ignition keys still with me. I need someone to come and cut a key just for doors at my sons house in roxburgh park.

Looking for a lock to be installed on the compactus door with keys. The door is Wood and the Frame is Metal

Replace a commercial letter box lox for an apartment and provide a new set of keys Location North Melbourne

Supply and replace existing door knobs both inside and out and supply and replace lock. This is a elevated rear balcony door and so does not require a lock on the outside. I require qualified locksmith with credentials. I require supply and install. I am OK with a mid tier brand. As long as functions and is silver as seen in images.

Deadlock and door handle lock to be replaced by qualified lock smith. Please quote for supplying the locks and also install for 2 X doors front of the apartment and back. 1. We want the get a good brand such as Lockwood. 2. Keyed alike is possible 3. Additional door enforcer or latch in the inside of both doors also good brand

Replace the door handle on my daughter’s bedroom (including providing appropriate handle) and make the handle on my son’s door easier to open

Glass door to be removed to fix the lock mechanism, then, door to be re-installed. Needs to be done on Wednesday 3 pm sharp.

Hi, I require either a carpenter, door installer, or locksmith to make an alteration to allow a latch to fit inside the strike hole again. The lock itself appears to work in that the key locks and unlocks the handle and latch of the lock, but the gate door won't ever lock. Looking closely, the latch doesn't sit inside the hole anymore and hits above it, due to a misalingment. When it was installed a couple years ago, it was working fine, however the door may have recenty shifted or warped, causing this, although I'm not sure. I am seeking someone to correct this, ideally by first checking the hinges and alingment of the door, etc. If this doesn't work, then perhaps remounting the strike plate higher or trimming off a bit of the metal at the top of the strke hole, or whatever you suggest. Best Regards, Mike

Door handle snapped off. Need to remove, supply and install a new door handle. No specific requirements. Doesn’t need to lock. It’s a meeting room door.

Hello, My name is Val and Im hoping I can find someone qualified that will install a new lock/handle for me. Specifically, I have purchased the following product: - Orion Smart Fingerprint Entrance Lock (the Grid Connect supported one - DL03HA) Not sure if this is relevant information, but I live in an apartment. Does bodycorp need to know anything? It's important I get the lock changed immediately as I'm doing this as someone stole my keys over the weekend and I'm scared they copied them. The last time you dealt with bodycorp, they took forever to get back to me, and I just won't feel safe until I get my lock changed. Currently my lock is just an old school lock that is locked and unlocked with a key. My door is a normal wooden door, I don't know what other information is needed. Feel free to ask. I'm free tomorrow, Tuesday 3 June. I have to take my car to get serviced at 8am, so I should be free sometime after 9:00am.

I need a locksmith to help with two tasks at my home. 1) To replace the cylinder in a door lock, and to provide a new key for that cylinder. So that it can be locked by a new key (lock is pictured. Ideally we can keep the lock, just replace the cylinder) 2) To help improve how one of my other doors closes and locks at the moment. (From time to time it semi closes but doesn't fully lock. Interested in whether there's anything we can do to solve that problem). I can provide photos of this door and lock if helpful.

Hi! I need someone to remove and replace a broken Whitco window winder lock (see photo). The key is missing and the lock is unusable. I’m open to alternatives and would prefer a budget-friendly option, such as the Remsafe Stainless Steel Window Lock (~$34.45 from Bunnings) — as long as it includes a key and secures the window properly. 🔧 What’s needed: • Remove the broken lock • Supply and install a compatible winder lock with key (preferably Remsafe) • Bring all tools and equipment • Ensure the window opens, closes, and locks securely I live walking distance from Bunnings Collingwood so it’s convenient to pick up a lock if needed. I have indoor cats – in case you have allergies 💰Please include the cost of the lock in your quote

Bought a gate lock from Bunnings and started installing but failed to get the task completed

Install door handle and privacy lock to outdoor toilet. Door is installed and needs to be buzzed a little on top left side.