Carpentry Jobs in Blacktown

Browse through over 500 Carpentry Jobs.

See what you could earn

$0

per month

Based on average carpentry task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Carpentry tasks in Blacktown

Check out what tasks people want done near you right now...

Need an experienced carpenter/decking handyman to make-safe an outdoor timber deck where a section has separated, creating a long gap/trip hazard. Scope (Make-safe only): Inspect the affected area and identify immediate hazards Re-fix/secure any loose decking boards (prefer screws) Remove/hammer down any protruding nails/screws Install a temporary but solid bridging/capping solution across the gap so it’s safe to walk over If needed, add minimal blocking/packing underneath at the join only to stop movement (no full re-levelling) Note: This task is make-safe only (not a full structural rebuild). If you believe a permanent structural repair is required (e.g., posts/bearers/re-levelling), please provide a separate quote after inspection (optional). Please include in your offer: Brief decking/carpentry experience (similar jobs) What materials/fixings are included (or what you’ll supply) Any assumptions/limits (e.g., max time/materials within this price)

Quakers Hill NSW, Australia

Mon Jan 12 2026

about 1 hour ago

Open

Need a joiner or cabinet maker to cut the cabinet door from 396mm to 375mm. It’s a J handle door, we have enough edge banding to seal it

Box Hill NSW, Australia

Mon Jan 12 2026

about 6 hours ago

Open

Need a five level cabinet (white coloured) installed in master bedroom - 550 mm wide and 1100mm length, 2200 mm in height and another self added to pre-existing cabinet 450 mm height above current, 450 mm wide, 1710 mm length. See photos below. Looking for colour match to existing cabinetry. No electrical work needed - no lights / powerpoints in existing areas.

Toongabbie NSW, Australia

Mon Jan 12 2026

about 7 hours ago

Open

I need a wooden display board made. It is a two panel foldable display board. It will hold little cards on the inside cavity of each panel which I will put in. It needs to go in the boot of my car, and it should look nice. It should be wooden or wood look, with varnish or presentation quality finish. I've attached a photo of the old one so you can see what I'm after. It just needs to be a little bigger and newer for better presentation. Specs: Height: 1m Width: 60cm each panel Weight: Less than 12kg Inside cavity: 2cm each panel

Franklin ACT 2913, Australia

Sat Jan 10 2026

2 days ago

Open

A handyman/carpenter or plasterer to repair damaged interior wall panelling in a small warehouse office. The wall is vertical timber/laminate panels (looks like tongue- and-groove or laminated chipboard). 3 different areas have the damage which may need patching and repainting or replacing the same design panel

Seven Hills NSW 2147, Australia

Fri Jan 09 2026

3 days ago

Open

I need a solid timber hinged door supplied (glass window preferably at the top, practically the same as the photos shown), installed, and modified for a garage converted into a room. Door opening: approx 2050mm high × 820mm wide Work required: Supply and install a basic solid timber door (most cost-effective option) Cut one round hole (~150mm) for portable air-conditioner exhaust Fit vent kit and seal around it so hot air doesn’t leak back in Important notes: This is a garage, door may be exposed to heat This is a rental — original door must not be damaged or used. New door must be removable / reversible No painting required This is a functional job, not cosmetic Budget: Looking to keep total cost frienldy as this is a rental and I would appreciate fairness and something realistic. Please quote labour + materials together.

Pemulwuy NSW 2145, Australia

Fri Jan 09 2026

3 days ago

Open

I am looking for an experienced kitchen installer/cabinet maker. Work required: Remove/demolish existing cupboards (current height approx. 820 mm) Rebuild/adjust cupboards to 900 mm height Install a dishwasher Install a stove/cooktop Install a kitchen island bench Notes: All measurements are uploaded Sample cupboard and island photos are uploaded.

Blacktown, New South Wales

Thu Jan 08 2026

4 days ago

Open

We need someone who is able to modify kitchen cabinets to fit the fridge pictured. top cabinet needs 10cm trimmed and reinstalled and right hand side cupboards moved over by about 12cm.

Seven Hills, New South Wales

Wed Jan 07 2026

5 days ago

Open

Task Description I am looking for an experienced and professional cabinet maker / carpenter to design, manufacture, and install a custom built-in cabinet and bench in my front room. The design is similar to the attached image and includes: • Wall-mounted cabinets • Tall storage unit • Integrated bench/desk with shelving • Clean, modern, and fancy finish Requirements • Proven experience in custom cabinetry and joinery • Ability to measure, design, build, and install • Experience with high-quality finishes (not flat-pack work) • Must supply materials and hardware • Strong attention to detail and neat workmanship • Able to suggest design improvements if needed Materials & Finish • MDF or plywood with premium laminate / polyurethane / veneer finish • Soft-close hinges and drawers • Smooth edges and professional finishing • Colour and final finish to be discussed Other Details • Job is for my front room (living area) • Please share photos of previous similar work • Quote should include materials + labour Looking for someone reliable who takes pride in their work and can deliver a high-end custom result. ⸻ If you want, I can also: • Make a shorter version (gets faster responses) • Rewrite it to target luxury cabinet makers • Add budget range wording (to avoid low-quality offers) • Adjust language specifically for Sydney / NSW Airtasker trends Just tell me 👍

Marsden Park NSW, Australia

Tue Jan 06 2026

6 days ago

Open

Browse all tasks

Last updated on 12th Jan 2026

Discover your earning potential in Blacktown

Earn money with every carpentry task

$400

per week

1-2 tasks per week

$1,000

per week

3-5 tasks per week

$1,400+

per week

5+ tasks per week

$1,732

per month

1-2 tasks per week

$4,330

per month

3-5 tasks per week

$6,062+

per month

5+ tasks per week

$20,800

per year

1-2 tasks per week

$52,000

per year

3-5 tasks per week

$72,800+

per year

5+ tasks per week

*Based on average carpentry task prices in Blacktown. Actual marketplace earnings may vary

Join Airtasker

Unlock new income opportunities in Blacktown

Explore carpentry related jobs and discover your financial opportunities

Type of carpentry job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Carpentry	$400	$1,000	$1,400
Staining	$600	$1,500	$2,100
Kitchen Cabinet Maker	$220	$550	$770

*Based on average carpentry task prices in Blacktown. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Carpentry Taskers in Blacktown

meet
Ganbileg G
9 years on Airtasker
- Rhodes NSW
5
Overall rating
221 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
252 tasks
meet
Stanley F
10 years on Airtasker
- Melrose Park NSW
5
Overall rating
1107 reviews
99.84%
Completion rate
The percentage of tasks successfully completed by the Tasker
1225 tasks
meet
Matt M
8 years on Airtasker
- Cronulla NSW
5
Overall rating
422 reviews
99.57%
Completion rate
The percentage of tasks successfully completed by the Tasker
469 tasks
meet
Rajiv D
4 years on Airtasker
- Colebee NSW
4.9
Overall rating
191 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
227 tasks
meet
Erfan R
9 years on Airtasker
- Eastwood NSW
4.9
Overall rating
562 reviews
99.85%
Completion rate
The percentage of tasks successfully completed by the Tasker
670 tasks
meet
Daniel S
4 years on Airtasker
- Bexley NSW
5
Overall rating
149 reviews
98.82%
Completion rate
The percentage of tasks successfully completed by the Tasker
170 tasks
meet
Karlo B
1 month on Airtasker
- Glendenning NSW
5
Overall rating
6 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
9 tasks
meet
Yawei X
2 months on Airtasker
- Homebush West NSW
4.6
Overall rating
9 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
9 tasks