Hire a trusted wall mounting service in NSW

I need a mirror hanging above a console table. The mirror is 19kgs and needs to be installed on dry wall. There are d-rings on the mirror. Thanks.

Need to wall mount a clothes dryer into a brick wall in laundry. - Due date: Flexible

We are not sure how to drill the brick wall in bathroom without damaging the brick. So need a professional to come in and drill the wall to hang mirror for us.

Make up - two ikea Alex draws - one brimnes dressing table - one malm dresser Hang - one circular small mirror - one light clock Fix - a door handle that is sticky (doesn’t always open)

Need to mount my TV and Dryer to the wall. Need a clean and strong job

Need 3 600x200 shelves and one 1800x495 shelves installed in laundry. Walls are concrete

I have a range of pictures that I want hung on an empty wall. I don’t have hooks or strips, need to buy them

Need a licensed sparky to install a Shelly Pro 3EM-3CT 63 (3-phase energy monitor) into my residential switchboard this Saturday. The job: Install 3 × split-core CT clamps around the 3-phase mains cables between the meter output and main switch Mount the Shelly Pro 3EM unit (DIN rail or adjacent) Wire a 240V AC feed to power the unit (from a spare MCB or existing circuit) Verify it powers up and CTs are reading What you DON'T need to touch: The Endeavour Energy revenue meter (Elster A1100), sealed, stays as is Service fuses Solar inverter or array wiring Any existing circuits What's already here: 3-phase board, dual supply (grid + rooftop solar) Elster A1100 meter, Endeavour Energy network Tenby Cables switchboard, Left + Right modules The Shelly unit and all 3 CT clamps — I have everything, just need it installed I'll provide: Full installation guide with wiring diagram (already prepared) Photos of the switchboard for your reference (attached) The Shelly Pro 3EM unit + 3 CT clamps (all supplied) You'll need to bring: Short length of 35mm DIN rail if there's no spare space on the existing rail (board looks fairly full, may need to mount a small rail segment on the back panel) 1 × MCB (6A or 10A) to protect the Shelly's 240V power feed Short lengths of wire for the 240V feed (L + N to the unit) Location: Kellyville Ridge, NSW When: This Saturday — flexible on time, morning or afternoon Budget: $150 – $200 This is a straightforward install, no modifications to existing wiring, no meter work, just clamp-on CTs and a small monitoring unit. Should take 30-45 minutes for anyone familiar with switchboard work. Must hold a current NSW electrical licence. Happy to see your licence number before confirming. Cheers!

1).Need 4x shelves put up, each come with floating brackets. Plus they will each need 2x small extra brackets underneath. There is a brick wall these will go into.... 2)Need another floating note pad put up. Not sure what surface is on the wall

Install 6 shelves into stud wall. Gap is approx 50cm wide. Will need to supply shelves will cover cost for those separately

The mirror needs to be mounted using mirror clips, brackets, or support clips. I don’t want to use adhesive double sided tape,because it doesn’t seem safe. You need to bring the necessary parts to fix the mirror to the wall securely; I only have the mirror.

Hi there, we need to hang 2 mirrors and 1 painting .

Hi! I have a few pictures that need to be hung. On cement walls. It will take an hour max. Thanks

I need someone to mount picture tv to concrete wall. There is a power point directly below it. If we can’t chase power in wall I would need installer to professionally run discreet white cable down wall. After 2pm today. Must be licensed electrician.

I have a job in two parts. Part one is removal of 31approx paints and careful re-patch of walls then a few weeks later rehanging of these paintings in new premises.

We have a large mirror that needs to be hung horizontally. We also have a shelf that needs put up & 2 pictures hung

Handy person needed to hang a wall mirror on a tiled wall - size approx 1m x 60cm Also to hand a toilet roll holder on a tiled wall Need it done tomorrow Mirror and roll holder supplied Must have your own drill / tools

I purchased some floating shelves and need somebody to drill the necessary holes in brick walls to help install them. Thank you!

Drill hooks to a brick wall (for bags and coats), also hang 4 pictures and a mirror on wall.

I’m looking for a skilled handyperson to help with two jobs 1. Balcony cat netting installation: Install/tension the cat netting on the balcony to make it secure with no gaps/sagging. 2. TV wall mount installation: Mount my flat-screen TV securely and level. While I have most of the hardware for both jobs… Please bring tools (e.g. stud finder, drill/appropriate bits, level, etc )