Find a local electronics repairer in South Moreton Bay

Initial Inspection and Fault Finding

I need a licenced plumber to replace the cartridges for 2 shower taps.

Install sub amplifier reverse camera. At strathpine 4500

Looking for someone experienced to inspect and repair my Simpson washing machine. The machine is having drainage issues and displaying an E20 error code. It fills with water and starts washing but stops before completing the cycle. We've manually drained the machine, removed the back panel and checked the drain pump and hoses for blockages. The pump impeller appears clear, but the issue continues. Looking for someone to diagnose the problem and provide a reasonable repair quote. Preferably available ASAP.

13 stumps from hedges to dig out of a slopping retaining wall. The stumps Do Not to be taken away.

Plumber required to replace 4x flexible braided hose connectors for kitchen and bathroom mixer taps around the house, each tap requires 2 connectors so need 8 in total. Hose connectors need to be purchased. Also have a old kitchen mixer tap that needs to be replaced with a new tap (new tap already purchased). Photos of existing hose connectors attached and the tap that needs to be replaced and new tap.

Remove old Basin Taps,Install New

Assemble flat-pack bar + seal gaps around garage door Looking for a handyman to complete two jobs: 1. Assemble a flat-pack bar We have a new flat-pack bar that needs to be fully assembled. All parts and fittings should be included. 2. Seal gaps around garage door There are noticeable gaps around the sides/top of the garage door frame that I'd like sealed to help reduce drafts, dust, insects and heat getting through. I've attached photos showing the gaps. I also already have some garage-door/weather sealing material, but I'm happy for you to advise if a different type of seal, insulation or filler would work better. The finished job needs to be neat and must not interfere with the garage door opening or closing. Ideally looking for someone with the necessary tools who can complete both jobs in the same visit. Located North Brisbane.

Need to remove and replace old kitchen bench tops, sink in one and small stove in another.

PVC Strip Curtain Replacement – Experienced Installer Required We need an experienced person to replace PVC ribbed strip curtains at multiple entrance locations within our food manufacturing facility. There are approximately 26 PVC strips across 5 entrance areas, with strips approximately 300 mm wide and 3 mm thick. The job involves: Removing existing PVC strips Measuring and cutting new strips to the required lengths Installing the strips onto the existing mounting system Ensuring correct overlap, alignment and secure installation Leaving the work area clean and tidy This is a straightforward job, but experience with PVC strip curtains is essential. We are looking for someone who knows what they are doing and can complete the job professionally and efficiently. Experience with cold rooms, commercial premises or food manufacturing facilities is preferred. Please include your experience, availability and labour cost when making an offer.

Stumps and weeds pulled out Type of gardening: Weeding Size of garden: Under 50m² Has green waste bin: Yes

Kitchen tab replaced but loose, the tap fixture has become loose where is attached to the countertop. The tab itself moves and wobbles when being used and needs to be tightened and secured properly to the countertop.

Front windscreen replacement

Replacing laundry tapware with quarter turn set. Tapware will be supplied Current is old 3 piece tapware. Have reseated body and changed washers but still always leaks after a while. Looking for install of bodies and tapware

Trim and stump grind 4 trees.

French Pattern floor tile. Front foyer. Approx 13m2. 150 square tiles on steps (x2). Approx 3m2.

3 hedge stumps from the front yard need to be ground, along with a grevillia stump from the backyard.

Have 3 walls that need a bit of a touch up/tidy for end of lease. Also Wood that’ll need a filler and sand and touch up on stairs

Please provide quote and availability. I've removed the old taps and shower head and cleaned off old silicon around them. I bought new valves, taps and shower head. Want to reseat tap seats and then install new valves, taps and shower head. Also seal up taps and head with silicon. The shower wall is ~5mm sheet and a hollow cavity behind, so not sure if need some sort of backing for the silicon.

The power circuit for the kitchen area keeps tripping at the switchboard. Even when all appliances are unplugged and nothing is being used, the safety switch/circuit breaker continues to trip randomly. Looking for a licensed electrician to inspect and diagnose the issue, identify the cause, and provide a quote for repair. Location: Bunya, QLD Please let me know your availability and estimated call-out fee.