Find a local electronics repairer in Outer South West Sydney

Hi, I need to remove these steps at Campbelltown. The good bricks can be reused, so there’s no need for removal or disposal of the bricks. Also need to concrete the area. Concrete materials materials can be supplied from Bunnings Location is on side of driveway Meter board and power supply Available 2-3 Meters away from the site Looking for options Thanks Due date: Flexible.

Bought a second hand gym set, need it assembled so it can fit into house, then carried upstairs and reassembled for use

Cut 7 stumps of wood fir fireplace

Remove two tree stumps approx 70cm height.

Remove stumps and roots of multiple trees in the back yard. 16 stumps in total Clear leaves and rubbish, tidy up the yard.

I need three taps installed properly as they are leaking or not working properly.

Been taken out of packaging

Installation of hand rails on this step for my elderly parents

I have a 1970s Onkyo X-3 4-Channel Surround Stereo System (integrated amp/receiver) that produces a loud, low-frequency hum when powered on. Hum is constant and unaffected by any front panel control (volume, bass, treble, balance, etc.) Hum remains identical regardless of which input is selected (Phono, Tape, FM, AUX) No cables are plugged into any RCA inputs — hum persists even with nothing connected Likely the aging electrolytic capacitors in the power supply that needs a recap though I'd welcome a proper diagnosis from someone experienced with vintage hi-fi equipment.

Remove stumps and roots of multiple trees in the back yard.

I have four tree / shrub stumps in my front yard. I would like to remove them so I can regarden / redo the front yard. There are two small stumps [#1 & #3]. One medium stump from a succulent bush [#2] - this one is close to the water meter so might need some extra care. And one medium stump from a short tree [#4] - this one is close to the front porch. Photos attached. Sorry about the one for the tree, there's a bit of grass around that one (that I really need to cut!) but diameter is about 10~15cm. Obviously would appreciate someone who's done this a few times so they know how to minimise impact on the front yard. And to work around services.

Replace existing kitchen and washroom mixer taps. I have purchased the replacements taps already.

Replace 3 outdoor lamps (not the bulbs). The wires are already there. I will buy the lamps, as in the picture.

Need gypsum work done with extra frame for tv mount ready. Both side. Square shape hole measure around 2x 1.2m. and painting. Extra frame for tv mount ready

Hi, could you please tell me how much it would cost to silicone 2 laundry taps as they are leaking and the silcine has come off. They are the taps that connect to the washing machine. It doesnt leak when the washing machine pipe is not attached, only when it is attached. Also if you could lift a brand new 60kg dryer ontop of the washing machine (onto a stacker thats been attached) without scratching anything please, will need 2 people to lift.

Two taps set up on kitchen sink to one sink tap mixer to one i have brand new tap mixer here

Installation only vanity and toilet With taps and fittings , shower head, bath taps. Must provide tools and silicone

I just need to replace 7 wooden steps of the staircase.

I need navman cruise650mmt usb soldering back on circut board. Already removed.

I need to remove the large vine creepers and the entire plants, as shown in the photos. It would be best to shred them into smaller pieces using a wood chipping device, making it easier to dispose of them in my green waste.