Find local power point installers in Inner West Sydney

Hi there, I've got three items of electrical work that need doing at my home: 1. Install a new power point in the wall of a wardrobe. There is another power point directly on the other side of the wardrobe wall less than 10cm away from desired place of the additional power point. 2. In the shed there is a power point with 2x buttons (one powers pool light, the other powers the garden lights). The pool light button continues to short out/stays on for 1-2 seconds and then turns off. The other button for the garden lights is working fine. 3. I have a garden light that needs to be fully replaced (I have the garden light ready to go), but needs connecting to the power.

Need 3 new power points (using mounting blocks) in garage. 2 x 2 outlets and 1 x 4 outlet. There is an existing power point that should be able to run off the new PowerPoint's. Owner to supply power points and mounting boards. Electrican to supply cabling and cabel trunking (approx 6 meters). Preference is cabel trunking verse rigid conduit. Need 2 lights installed (owner to supply) 1. Replace 2 existing pendant lights (over kitchen bench) with one new pendant light. 2. Replace outside front door sensor light with a new sensor light.

Faulty hanging power points not working in restaurant, we use for rice cookers

Isolate 2 light fittings. Delete 2 light fittings. Isolate a light switch and power point.

Need electrician replacement of outdoor PowerPoint which has been damaged by the heavy rains. Also looking to have the PowerPoint changed to a double outdoor PowerPoint rather than single. PowerPoint has its in direct line to the switchboard

The powerpoint is not working in the backyard patio area. Need to find a way to make it live

I'm looking for a licensed electrician to install simple outdoor lighting in a new pergola, as well as one external power point on the wall. Details: Pergola will be newly built (by a carpenter) Lighting doesn’t need to be anything fancy – just a cost-effective solution for evening use One outdoor power point to be installed in a nearby wall Property is in Concord, 2137 Timing is still to be confirmed but I’m looking to lock in someone who’s happy to coordinate around the builder’s schedule Please let me know your availability, estimated cost (including materials if possible), and any questions you may have. Thanks so much!

Garage has power cables in conduit attached to the walls. We need 3 extra double power points installed branching off the conduit. Two are required close to the existing conduit and one needs 3 metres of additional conduit installed. You provide all materials (new conduit, power points, connectors) The first picture show an existing power point. The second picture shows one location that needs to have a power point added. The third picture shows another location that needs a power point about a metre below the conduit. The fourth picture shows the location of the last power point which is about 3 metres from picture 2 (through the back of a cupboard). No painting required.

Change power point straight swap

Replacement of led light switches and PowerPoints, materials supplied, approx 15

Install an external power point on brick wall for roller door. Power is available on other side of this single skin brick wall

Licensed, insured electrician needed to fix a switch. The light switch is out of place, makes the light flicker and sparks.

Looking for someone to help install an additional double GPO in our laundry room. Ona tiled surface. There is an existing one already. We would like an another installed below bench height.

Install 15 Amp outdoor power plug close to the main switchboard.

I need two Power Points installed There is a power point where arrow is Patching may need to be done as well

power point installation for instantaneous water heater. Power board in granny flat right behind the water heater

Replace: - 2 power points (single) - 9 power points (double) - 2 power points (double, low height of 45mm - see pic) - 1 power point (double) with extra switch (for fan) - 1 light switch (vertical) - 2 light switches (double) - 1 light switch (3 switches, including 2 dimmers - see pic) - Exhaust fan (replace - see pic) I will provide all the materials for the above. Also, provide under cabinet lights (to replace fluro) for: - 1.8m - already connected to 1st switch inside cabinet - 0.7m - to be linked to the 1st switch through 2 cabinets - 1.5m - already connected to 2nd switch on cabinet See pics. Please provide good quality under cabinet lights. If dimmable, will need to replace 1st switch to add dimmer.

Looking for a licensed electrician to install 2x double GPOs. Power points to be installed in upstairs bedrooms. Roughly marked in attached photos. There are no other power points nearby Roof is pitched, material of outside upstairs is weatherboard, downstairs is brick veneer. Electrical switchboard recently upgraded with RCD protection. Job in Ashbury.

Add a 1x power point in bedroom, + 1x ethernet point

Supply and install a new outdoor PowerPoint toward the front of our property on an existing circuit . House is weatherboard.