20 Power point installers in Adelaide

Dishwasher power point needed please

I need a power point connected to already exisiting wires on the floor. Needs to be floor mounted.

Hi, Looking for an electrician to change about 15 switches/power points for me. I have bought the new switches/dollys from Bunnings and have unscrewed all the power points. Please make me an offer. Was thinking between $80-$100, but I’m not sure what is reasonable. Can pay in cash/bank transfer. Available Dates/times: Fri 22 - anytime before 1pm Mon 25 - anytime after 2:30pm Tue 26 - anytime Wed 27 - anytime

electrical work to move two power points and install a ceiling light fitting

We are installing a new kitchen and need 2 single power points upgraded to quadruples. We are also putting in a dishwasher and a new electric oven and need an isolation switch for the oven. The dishwasher won't be against the wall so we need a power source to run to it through the cabinets. We also had a fan installed in our lounge room but the last electrician put the fan switch on the wrong wall. We need the fan switch to be connected to a switch on the other side of the room and the light switch to be where the fan switch currently is (I hope that makes sense). If possible we would like an itemized quote as we may decide not to go ahead with certain things. Thanks!

Needing a licensed electrician to remove a hard wired sliding gate motor and fit a external power point. Power point is already supplied, just need to bring your own hand tools

I am looking for an electrician to supply and install replacement faces for seven power points, two light switches and one blind cover using slim line products. See example picture.

I have purchased a IoTaWatt unit and need it to be installed by a licensed electrician. IoTaWatt is a power monitoring device (https://iotawatt.com/) which reports power usage via wifi. It needs two power points (one for it's own power and one for reference) so you will need to install two power points in or near the fuse box. The unit then has sensors that clip around the insulated wires. You will not need to do any software installation, only the hardware part (I'll do the rest).

Install and provide Certificates of compliance for:- 2 x double outlet GPO's 2 x Recessed double outlet GPO's At a Commercial Office In Adelaide 26 Flinders Street Onsite parking available 1.9m Maximum Clearance

Need to shift power point up the wall for tv installation. Wall will need to be chased.

New verandah. Want light relocated and power point installed. Kilburn area.

Install PowerPoint unit for unit South tce

Need additional power point for security alarm unit. Location : Mount Barker Avalaibility : weekends Urgency : immediate

Note: No rush on time frame. I'm after the bottom 2 gang to be changed to 4. Above that, I want a 2 gang PowerPoint installed. Needs to be a clean install.

I need a double power point put in. The wall is drywall and has a power point on the other side of it a bit higher up. Licensed electrician only

Have recently upgraded my kitchen. Two small jobs need doing: 1. New downlights have been installed, however, the old switches weren’t changed. There are two in the room. Both just on/off switches. Need both of these swapped for dimmable switches 2. Old daggy 2 point power point needs switching out, just to modernise the look

I want to have two power points install in island, also one in living room

Spare room has a TV installed, we need a new aerial point and power point added.

Install a hard wire smoke alarm the one I have is battery &old and put in a power point outside for a new hot water system . For a unit in South TCE city

Need power point done in the hall way for sensor lights