Find local power point installers in Melbourne

garage with power needs Supply and Install 2x Double GPO's and Certificate of Safety

Hi, I'm looking for a licensed electrician to provide a written quote and install a standard 10A power point inside my ground-floor garage for charging a Tesla Model 3 using a Tesla Mobile Connector. **Important – Victorian EV Charging Requirements** A dedicated wall-mounted EV charger (such as a Tesla Wall Connector) is NOT required. The Victorian Government confirms that EVs can be charged using a standard Australian 10A household power point (Level 1 charging). Reference: https://www.energy.vic.gov.au/renewable-energy/zero-emission-vehicles/charging-your-electric-vehicle The installation must still comply with Victorian electrical safety requirements, applicable Australian Standards and Tesla's instructions, including any dedicated-circuit requirements. **Existing Setup:** - Existing outdoor power point on the upper-floor balcony, connected to my electricity meter. - Garage located approximately two levels below. - Preferred cable route is vertically down the external brick wall using protective conduit. - New standard 10A outlet to be installed inside the garage, protected from weather. **Scope of Work:** 1. Assess whether the existing balcony circuit can safely support regular overnight EV charging. 2. Provide a written quotation for landlord and body corporate approval. 3. Install a standard indoor 10A outlet using the existing circuit only if compliant. 4. Ensure appropriate electrical protection, earthing and testing. 5. Provide a Victorian Certificate of Electrical Safety. **Budget: Maximum $250**, including quotation, labour, materials, GST and certification. I am renting, so installation can only proceed after landlord and body corporate approval. If a dedicated circuit or additional electrical work is required, please explain before proceeding. I am seeking a safe, compliant and cost-effective solution without purchasing a wall-mounted EV charger. Photo of proposed installation route attached. Thank you.

I own an apartment that has two power points and an exhaust fan in a bathroom that have never worked since I bought it in 2023: I’d like a licensed electrician to take a look at what needs doing. The unit fit out was done in 2004. If it needs replacing, ideally you can install a new exhaust fan on the day. It looks the same as the picture attached. I’m happy to pay additional $ for parts as required. Unfortunately there’s no parking in the building but there is street parking and parking garages nearby. The unit is in the CBD near town hall. This Saturday or Sunday only please, and please note what’s included in your offer.

Install power point in laundry – existing cable Looking for a licensed electrician to supply and install one power point beneath a future laundry bench for the washing machine. A previous electrician ran a cable from the switchboard into the laundry. It needs checking and connecting to the new power point. Walls are concrete. Photos show the switchboard, existing cable and preferred outlet location. Please quote including labour, materials, testing and Certificate of Electrical Safety.

Looking for a fully licensed and insured electrician / ACMA registered cabler for electrical and data work in a double-storey townhouse in Armadale. We need this completed urgently. Please provide an all-inclusive quote (labour + standard materials/plates) and let me know your earliest available date. Scope of Work: 1. Power Points Relocate: Move 1 existing power point in Bedroom 1. External: Supply & install 1 weatherproof external power point on the terrace. New Internal: Supply & install 3 additional double power points (locations to be confirmed on site). 2. Data & Networking run cabling/install 2 network access points (1 on Ground Floor, 1 on Level 1). Device will be provided 3. TV & Internet Cabling Relocate TV point and HFC NBN point. Install wall cavity conduit/ducting for a wall-mounted TV setup to conceal cables neatly. Key Details & Requirements: Property Type: Double-storey townhouse. Location: Armadale, VIC (easy parking/access). Compliance: Must be an A-Grade Licensed Electrician and hold relevant ACMA cabler registration for data/coax cabling. Certificate of Electrical Safety (COES) required upon completion. Materials

I think the heater blew up the power in the power outlets in my bedroom, I need it fixed asap

Replace two pendant lights with new ones as shown in the pictures. the new lights are in the box, you will need just to put the main body up, I'll dress them up myself. the area of the new powerpoint as shown in the picture. There is a powerpoint behind the fridge, so you can run the extension from there. I need white, double powerpoint.

Hi there, I am looking for a fully licensed and insured electrician to help me get power to my garage. The Job: • I need a new power point (GPO) installed in the garage. • needs to support two fridges. Both are 5.3amp • The power needs to be sourced from an existing power point/outlet located in the laundry • A new cable (approximately 20 meters long) needs to be run from this existing source, out to the garage. • I believe a junction box may be required to connect the new line to the existing power source, but I will leave the exact method up to your professional judgment. • Please note: The cable will need to run outside. I may have enough conduit which can be used. Requirements: • Must be a licensed electrician (happy to provide certificate of electrical safety/compliance upon completion). • Please bring all necessary materials (cable, junction box, new power point, etc.) • I am looking for a neat, safe, and professional job. Images shows where outside wires to go. Power can come from either the larger switch or the PowerPoint in the images below. They are both in same room.

I’m getting a new hot water system installed on Thursday (29th Oct) and require an outdoor power point installed. Preferably for Wed 28th Oct. Thanks!

Will be at home. Apartment - Due date: Flexible

I need one power point disconnecting and removing ( I’ll patch over plaster work after) and replace two dimmer switches with regular switches ( you to supply matching switches)

Disconnect 2 x power points and replace one for a rangehood

I have installed a wall mounted TV and the power and antenna cables runs down the open wall now and looks bad. I would like a new power socket and antenna socket placed behind the TV to hide cables. The wall is plaster also.

Replacing my existing electric hot water system with a new Rinnai 50L unit. The existing system is hardwired, while the replacement comes with an electrical plug. Need a licensed electrician to disconnect the old connection and install a suitable power point using the existing wiring, provided it meets safety requirements. Please include materials, testing and Certificate of Electrical Safety.

I have an old surface-mounted GPO that needs replacing. Two old rigid PVC conduits enter from above — the left is the incoming supply and the right continues to another working GPO. The downstream GPO needs to remain connected. Looking for supply and installation of a suitable 10A weatherproof surface-mounted GPO, with any conduit adjustment required for the installation. There is also an ceramic fuse that needs checking and replacing with the fuse wire. Please let me know your quote. Thanks.

Install two dual power points in wall connecting to existing power supply in wall to power two speakers

We want to put a power point in wall to mount tv

I’m looking for a licensed electrician to install one new double power point on a plasterboard wall in my apartment. There is an existing double power point approximately a few metres away near the marble shelf, which I’d like the new outlet to potentially be supplied from. The job: * Install 1 x standard double GPO underneath the existing picture frame (see photo). * Ideally run the cable inside the plasterboard wall cavity from the existing power point. * I want no visible cabling or plaster chasing between the two points. * Only the necessary cut-out for the new GPO. * Please assess whether the existing GPO/circuit is suitable for the additional outlet. * Supply and install the GPO. * Test and leave the installation compliant and tidy. * Licensed electrician only – Victorian electrical regulations apply. Budget: $250–$300 Seeking a fixed price agreed before starting. Please quote including labour, materials and installation and confirm you are a licensed electrician in Victoria. Photo attached showing the existing socket and proposed location

Looking for a licensed electrician to complete the electrical work required for a new heat-pump hot-water system being installed ( new double power point) Hot water system: Midea RSJ-23/300RDN7-L2 280L heat-pump hot-water system with electric element. Job details: • New Midea unit will replace the existing Aquamax gas hot-water system shown in the photos. • A suitable weatherproof outdoor Double power point/electrical connection is required for the new Midea unit. • There is already an external power point supplying the ducted heating approximately 2–3 metres away. • Good access underneath the house via the subfloor. • Photo of the existing switchboard is attached. • Electrician to determine whether an existing circuit can safely and compliantly be used/extended, or whether a new dedicated circuit/RCBO is required for this particular Midea unit. Please quote your best ALL-INCLUSIVE price for everything electrically required to have the Midea ready for connection, including labour, weatherproof power point, cabling, circuit/RCBO if required, materials and electrical compliance/safety certificate. Please base your offer on the information and photos provided and advise in your offer exactly what is included. Must be completed by a licensed electrician and fully compliant. Thankyou 😊👍

Installation of a double power point in place of existing single power point and install additional double power point in kitchen. Walls are brick and plaster.