Find an experienced concreter in WA

I would like to concrete my backyard. The area is approximate 76m2. I like to remove all existing artificial grass and brick paving and replace with concrete floor.

About 20m2 / 10m x 1.5m rough area looking to get concreted, with some of that wanting to be stamped to look like pavers if possible. Wanting to put a small shed on the not stamped area, so unsure about thickness needed but open to professional opinions. Also earthworks would be needed too :) Budget is negotiable, unsure of how much a project like this would cost so just put an amount in for the time being.

Price is for a concreter to come and inspect the site and have a conversation with me about next steps. Not to complete the job. Looking to get some concreting done at the front and back of my town house near the city. Have had limited luck getting a response from companies around Perth, probably due to the lack of size. Images show the areas in question (via Realestate.com), looking to remove the brick and replace with a nice exposed concrete. We are after an exposed aggregate in a lighter colour.

Concrete slab required to rear of property. Slab size 5500 x 2600, with a small additional bit that's 1500x1000 Depth of form averages 100mm Approx 2 m2 of concrete reqd Rear access only by wheelbarrow - approximately 30m from front of house to pad area. Have formed up the area ready for concreting.

Require 100mm thick concrete shed pad Dimensions are 1.2m x 2.3m Soil to be removed as part of job - see photos Easy access off carport and driveway

Concrete has been cut out allready. Just need concrete done 2000 x 500

Old concrete needs to be jackhammered and removed and new concrete poured

Steel reinforced concrete 5.5m, 1.5m, 100mm thick Will require concrete pump, area is 20 meters away and on a second level away from driveway.

We would like our backyard concrete aggregate flooring honed and refreshed please

4.2 x 2.7metre concrete pad needed for small studio. Sand to be removed as needed, area levelled and firmed for pour.. Please note the current blocks in site are 3.9m x 2.2m so pad will be slightly larger. Rear laneway access.

Demolition and Removal of 18 sqm concrete slab plus removal of 4.5 metre concrete footing. Plus cut a straight line along the edge of a concrete path.

Concrete bottom end of the drivway around 15-20sq metres

My hubby is looking for someone to assist in drilling holes and concreting in posts for a retaining wall. Ongoing cash work required. $50/hr for skilled labour, $35/hr for general hand

Amount posted is just because Airtasker requires you to enter an amount, please provide a reasonable quote. I need a section of concrete replaced following a plumbing repair. The section is ~2m x 1.3m but the hole is much smaller. I had a previous repair done where they matched the exposed aggregate, unfortunately that concreter has retired now. I understand that it may not match perfectly but please do a reasonable job. Photos show the section needing repair and the previous match job (new side is the side with the pipe through it).

55 sq meters of paving to be removed and put decorative concrete. Can help with the task just need someone with experience and tools.

Site preparation - 90m2 approximately to levels specified. Tasks in detail below, 50mm level reduction required from current levels. Compact ground and ready for laying rebar and pouring concrete.

Looking for someone to do aggregated concrete for a 7x3 area

The previous owners were going to put a granny flat in but it didn’t get finished so there’s 12-14 concrete footings that need to be taken out and removed They are in the ground and I’m not sure how deep.

Hi - we have a soak well that i would like to get cut down so it is flush with the ground, probably need about 10cm or so cut off. Concrete cutter needed

I need someone with a demo saw or similar to do one cut through an exposed aggregate concrete path in Maylands. The width of the path is 1400mm and depth 75mm. Doesn’t need to be perfect and no requirement to remove any section of path. The red line on the photo is where the cut would be.