5 Concreters in South Morang

Hi; How much would charge for a small job of grinding and sealing concrete pavings as follows: 1- Exposed aggregate paving 1.4 x 7.75 m (about 11 m2) 2- 4 x3 m (12 m2) of plain concrete paving 3- 1.5 x 2.2 (about 3.5 m2) of plain concrete paving. I will supply the sealer from another job (urethane sealer). Regards

about 25 retaining wall, either wall stones or posts and slippers

Appx 130 sqm of concrete driveway and paving need to be removed

Resurface stencil concrete

aprox 1.2 meter and 10 mm wide crack in concrete. there was a tree root going underneath which i hv removed.

I had a bad experience with the concreter who covered our termite access points with concrete. This job is to cut concrete enough to access 2 termite access points from 2 parts of the house.

Required is a concrete grinder/mower operator to grind about 60 square meters of newly poured concrete the surface of which has been damaged by rain. The grinding depth is 5mm. Offers must include grinder hire, operating charges, time needed, sealing 2 coats with non-slip clear sealer a package. Please, note that in many areas you can insert your fingers under the spirit level as an indication of the surface unevenness. Offers above and below budget are welcomed.

20 square metres of plain concrete.

I have an existing pine retaining wall and a garden bed. Need to pull it out and put new sleepers

We had an ordinary job completed by a previous Concreter. Needing this section marked with tape cut out and removed and then re done as a 300mm deep footing or pad which will hold our pizza oven that we are going to build on top. We are tiling this area and the previous Concreter also did not make the edge thick enough so we need to pack with concrete to make the thick edge. Lastly the step picture needs to be removed also and redone properly as it is not straight and as it wasn’t pinned to the other concrete, it is starting to pull away already.

Pull up 9sqm if concrete and take away. Concrete has been cut, might need a couple of more cuts to make blocks smaller.

Hey Guys, I need someone that can make a concrete slab for a rainwater tank re installation. The slab must be 25 MPA and 100 mm thick with F62 Steel Mesh. The dimension of water tank is 1.95 m * 2m and the area that needs to be concreted is 2.25 m * 0.85m. Before i assign the task to someone, I need to know how you will make the slab and reinstall the tank. In addition the waste needs to be disposed off. I will attach pictures in regards to the current condition of the are where the work needs to be done. Thanks

I need our concrete driveway cut up as so we can remove it and prep the space for a new concrete pour. Approximately 45m2 of driveway to be cut in 1 meter cuts for removal. I have attached a photo of the area.

I have a small area in my backyard that I am told measures 1 to 1 1/2 m3 that I would like concreted