Find local mobile mechanics in Blacktown

Must be a registered mechanic and be insured and provide a guarantee of work. I need a comprehensive pre-purchase inspection on this 2011 Lexus LX570, starting with a full OBD-II diagnostic scan and a rigorous road test to evaluate transmission shifting, engine performance, and 4WD engagement. Under the hood, specifically check the 5.7L V8 for common cam tower oil leaks and valley plate coolant leaks, alongside a general assessment of all fluids, belts, and hoses. Hoist the vehicle to thoroughly scrutinize the frame, undercarriage, and wheel wells for any signs of surface or structural rust, while also inspecting panel gaps, paint consistency, and factory weld points for any evidence of historical crash damage or concealed bodywork repairs. Finally, assess brake and tire wear, and test the Active Height Control (AHC) suspension system through all its height settings to ensure it operates smoothly without fluid leaks or accumulator pressure loss. Provide full photo suite of car and a written report of findings.

Note: Happy to come to your workshop to save on callout fee if reasonable. Looking for a qualified/licensed mobile auto electrician to install and route a Victron eyelet connector lead with an inline fuse onto the main 12V battery of a 2025 Kia Carnival GT-Line Diesel. Job Details & Scope: Vehicle: 2025 Kia Carnival GT-Line (Diesel) Equipment: Victron Energy fused eyelet connector cable (M8 ring terminals) Goal: Hardwire the eyelet lead to the battery terminals and route the quick-connect plug to a neat, accessible spot behind/near the front grille so the car can be charged on the driveway without opening the bonnet. Key Requirements & Best Practices: 1. Safety First: Remove the inline fuse from the harness prior to installation and reinsert only once all wiring and connections are finalized. 2. Solid Connections: Correctly torque eyelet terminals to battery posts/distribution block without disrupting existing vehicle sensor wiring (e.g., BMS sensor on negative terminal). 3. Protection: Encase the entire wiring run in suitable automotive split-conduit (corrugated tubing) to protect against engine heat, vibration, and sharp edges. 4. Clean Routing: Securely cable-tie the harness along existing factory wiring paths, keeping it well clear of moving engine parts or extreme heat sources. 5. Weatherproofing & Access: Position the quick-connect plug at the front grille so it is easy to reach, securely anchored, and protected from water/road debris when capped. 6. Testing: Verify correct polarity and test voltage at the quick-connect plug once the fuse is reinstalled and test battery charging. Tools & Materials: I will supply the Victron eyelet connector cable (with built-in fuse holder). Please bring your own standard auto electrical hand tools, cable ties, multimeter, and automotive split conduit

Cbr650r 23model 9000kms need minor service and maybe a brake fluid replacement

I’ve been hearing a noise from drivers side front suspension when going over bumps and now today I’ve noticed this when I open my bonnet I’m not sure if it’s connected to the noise as I’m not an expert. But compared to the passenger side it is raised and causing my bonnet not to close flush now. My car is a 2009 Holden commodore.

Need oil and filter change, fit new spark plugs, will supply all parts to be installed.

Audi q5 2017 riverse camera stop working. Need to check wiring or anything else. Fixing cost

Engine Head gasket repair

I have a small truck. I have an electric issue with the wires connected to the battery. Battery is new, alternator is properly working. But i have issue with the wires, so everytime i want to turn it on i have to jump start it. Need someone to fix it.

Hi, I will need a mechanic to do a thorough inspection of the car, what are the issues and what are the cost of the repairs. Test drive the car. Advise whether the car is worth and maybe help with the negotiation. Maybe do another inspection after if the inspection if the deal does not go through Budget is for the initial inspection. Planning on buying a manual car. Will give more information after and the car we will be looking at. Preferred time on weekends is around 6pm or afternoon in a weekend.

Motorbike mechanical assessment. Bike is still in near new condition but had been in and out of storage. Each time it comes out of storage I have needed to replace battery and/or relay switch, and I believe the either the same or another small issue will be the cause. I have replaced battery, and need someone to identify issue ($100) and for an additional agreed amount, repaor the issue.

Helping with Apple play which has stopped working in car.could be a fuse

Change the brake pads for Renault Captor

I’ve had a diagnostic scan done and been told by local mechanics my right rear sensor needs to be replaced. But every time I try to book in with one they are always busy so looking for one that will have the time to actually repair it. You will need to provide the part so make sure to include that in your offers please thank you! It’s a 2009 Holden commodore ve.

Suzuki Hayabusa wind shield fix

I would like to change Mechanic change Camshaft Position Sensor 90919-05025 for Toyota Camry 2000 model engine light on engine error Cood on the scanner The OBD-II trouble code P0340 indicates a "Camshaft Position Sensor 'A' Circuit Malfunction

I brought a car unseen. The engine needs to be put back together and new parts installed which I have brought. New parts are the following Valve seals x2 Injectors Spark plugs, colis and leads Harmonic balancer Timing belt Water pump Radiator and hoses Needs to be a qualified mechanic No back yard mechanics I will ask for proof of licensed business and motor repair license

Per purchase can inspection

Car Repair + Starter Motor – 2002 Mitsubishi Verada Ei KJ Hi! I need an experienced mechanic to help get my car back on the road. 📋 VEHICLE DETAILS: • Make/Model: Mitsubishi Verada Ei • Series: KJ • Year: 2002 • Body: 4 Door Sedan • Transmission: Automatic • Engine: 3.5L V6 Multi-Point Injected (Unleaded) The job includes: ✅ Diagnose and repair the vehicle ✅ Source a compatible starter motor for the above exact model/spec ✅ Remove old starter motor and fit the replacement The car is not starting, so a mobile mechanic or I can arrange NRMA to tow the car and drop at to your location – please mention this in your offer. Please quote parts (starter motor) and labour separately so I can compare offers fairly. Looking for someone reliable, experienced with Mitsubishi/Japanese vehicles, and ideally available soon. Message me to discuss location and timing. Thank you

I need a licensed mechanic to service my car, someone who works on 4WDs and owns one. My car is a 2014 D22 Navara

mobile mechanic / pre-purchase inspection needed TODAY 12pm Looking for a mobile mechanic who can do a pre-purchase inspection today at 12pm in Blacktown. Car: 2014 Subaru Forester 2.5i-S (2.5L boxer, CVT, AWD). Cheers!