Find professional metal gate repairs in Sydney Eastern Suburbs

Looking for someone to repair our metal front gate. One of the welded joints has come apart and the metal section has detached. Would like it reattached securely and restored to its original position. Please see photos. Ideally looking for someone experienced with metal gate repairs/welding.

I need two metal gates in Warm White, design pic attached. Accepting this task is for a quotation ONLY.

Install a lock so that the metal gate is lockable

Hi there, I need help removing the old side gate and installing a new aluminium gate (please see the attached photo). The new gate must close securely to keep my puppy safe. I don’t have the new gate yet, so I would like you to come and take measurements and supply the new aluminium gate as part of the service. Side gate size around 110cm X 200cm Offer price including installation service & side gate Requirements: • Please have experience with gate or metal fence installation

Hi there, I need help fixing a metal gate that won’t close properly (see photo attached). It looks like the alignment or latch mechanism might be the issue. The gate needs to close securely and operate smoothly. Plus, I need to change new door lock. Requirements: • Please have experience with gate or metal fence repair Price is open for negotiation.

Looking for someone to repaint a metal gate in white.

Need to minimise water entering the property

Hinge bolts have sheared and gate has come down. Bolt remains in gate and gate post hinges and will need to be drilled out/removed. New bolts/pins need to be installed and gate re hung. It is quite heavy - too much for me to manage alone. It seems that the hinges are covered top and bottom. So bolt/pin in instead in bottom hinge and gate hung on top. Can't tell if bolt/pin is threaded or not

Attach metal gate post securely to brick wall. No materials supplied. We live close to the sea so screws must be rust proof.

I need someone to push the metal out as it is caught. Should only take 5 mins

The posts supporting our front gate need to be drilled into the sandstone, either dynabolt or using angle, to support the weight of the gate. The posts were cut to install the brushwood. I also have some privacy screening to attach to the gate once attached. I will pay extra for the parts. The weight of the gate has cracked the sandstone step, I will pay extra if you can affix this too.

Steel gate is dropping/sagging and is catching on the tiles.

My front gate needs a fresh coat of paint. It was powder coated 15 years ago but now shows signs of age. Needs clean and rust treatment in a few spots followed by metalshield epoxy paint all over. Paint and treatment products supplied.

Metal gate has broken off its hinge. Needs to be reattached - Due date: Flexible

Removal of old metal gate 4 - 5 ft tall from side driveway. The gate post attached to side of house on one side.. preference would be to take the gate away as well. - Due date: Flexible

Reattach metal gate hinge to support post

fixing brackets need to be re placed. - Due date: Flexible

Rusted corner of sliding gate needs welding - Due date: Flexible