Find an experienced garden edging expert in NSW

Garden edging We have the pavers , just need them to be laid in a concrete bed, replacing the old edging ,there are some curves involved. We will remove old pavers . Cheers

Looking to replace the existing wooden garden edging with sandstone blocks (likely from Bunnings but open to suggestions). The yard is sloped so the edge going past the tree (last pics) is on a downward slope. Unsure on price so am open to offers. I’m happy to pay and organise the sandstone blocks so they’re on site and ready to go Type of gardening: Other Size of garden: 50m²-150m² Has green waste bin: No

I would like garden edging along the existing hedge and then create a footpath to the back of our yard. Preferably edging cut along the back width of the yard as well so I can section off our trampoline from the grass. Happy to supply the edging and stones or you can organise if you prefer with your trade discounts. Type of gardening: Other Size of garden: 50m²-150m² Has green waste bin: No

Require new installation/repair of existing garden edges retaining block wall, currently single layer half section, need to raise it up to 3, and install a new wall on other half section. In addition, repair of partially sank section. AI images attached for expected new look. Measurements are 10 metres long wall, 5 on each side of the PVC downpipe, and about 2.2 metres on short corner. Existing block type also provided, will require same type of blocks.

I need garden edging preferably using Corten steel. And weed matting. Garden will be 2 tiered with steel edging for the borders.Steel edging will also be required to go along side of house garden ( approx 4 metres ) to replace existing cement border

Install terraform steel garden edging, transport rock from front to back yard, pot plants. All materials supplied. Approx 8m x 1m

I’m looking for someone experienced to install approximately 14 metres of garden edging along a mostly straight line. I will supply the edging and stakes/fixings. The job involves: Installing approximately 14m of edging Digging/preparing a shallow trench as required Making sure the edging is straight, level and securely installed Backfilling and tidying up once finished There may be some hard ground/rock or potentially bedrock underneath in parts of the area.

Looking for someone to assemble/ install curved garden edging. Approx 14m in total. Pictures are of site (I had only purchased some of the edging when taking these photographs but I’ll have enough materials for the job; I’ll also separately afterwards be sourcing more mulch/bark. Also pictured is a reference image - hoping to achieve an organic/ curved shape.

Install 25 lengths of 200x50x2.4m treated pine sleeper edging with off the self stakes and bugle screws. Will need own tools - electric saw and drills etc Type of gardening: Other Size of garden: 50m²-150m² Has green waste bin: Yes

I need ro relocate the pebbles circled in blue to the rear adjoining area, shown in white strips, and lay a plastic membrane 1.5m (supplied) from the house side and Pebblelock pavers (bunnings product supplied) as well as some new grass (also supplied). Put new pebbles in place (supplied 3-4 tonnes) and compact these with a whacker or similar, suitable to drive on. Thanks Jon

Need the grass edging along my nature strip (between footpath and street) trimmed and tidied up. Creeping clover/weeds are overgrowing onto the concrete path and need to be cut back to a clean, straight edge along both sides of the strip. Roughly one property frontage. Just need it neat and defined — mower/whipper-snipper or edging tool, whatever gets a clean line. Type of gardening: Lawn mowing Size of garden: Under 50m² Has green waste bin: Yes

I’m looking for someone to repair two small sections of brick garden edging in my backyard. The total length is approximately 3.5 metres across two sections. I have the bricks and I have included a photo of the existing pattern to follow. One section may need a small amount of backfill, this is where a large tree was removed.

I am planing a new garden installation and require garden edging Approx 30 metres Type of gardening: Other Size of garden: Under 50m² Has green waste bin: No

Wooden garden edging supplied and installed about 20 mts of edging Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

Lawn edge requires sniper

See attached photos for work involved. Happy to negotiate price. In summary: - Replace timber edging around garden - Build a L-shaped in-ground garden bed / planting area (should be food safe) - Replace the timber tool shed lattice - Replace clear polycarbonate sheet on top of tool shed - Straighten clothes line posts I'm happy to send dimensions to get indicative quotes. Should have experience working on such projects. Location is Panania NSW 2213.

I need lawns whipper snipped, and Weeding soraying and removal of small tree suckers removed or poisoned Type of gardening: Weeding, Whipper snipping, Garden cleanup Size of garden: Above 300m² Has green waste bin: Yes

Looking for someone to lift these pavers and re-align them straight to make it look neat. No need for concreting. Then level out the pebbles. Any excess pebbles can be wheelbarrowed to another garden bed nearby. Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

Supply and installation of about 50m of garden edging. Cor-ten steel. It is already mapped out, just need to be supplied and installed. Type of gardening: Other Size of garden: Under 50m² Has green waste bin: Yes

Tasker with attention to detail and handyman or landscaping skill needed to install approx. 30 metres of aluminium garden edging (Link Edge) in my front and back yard (15m worth approx each yard). Product: Link Edge Scope of work: • Install approx. 30m of Link Edge to create clean separation between lawn and garden beds • Straight lines and corner joins • Prepare ground where required (minor shovelling/levelling) • Secure edging with spikes and ensure it is straight, level, and stable • Join sections neatly for a tidy finish *Pink lines in images indicate where link edge edging is intended to go. Tools: You’ll need your own angle grinder, mallet/sledge hammer/shovel.