Find a local electronics repairer in Glenbrook

*New vanity connected ie mixer tap, waste pipe *Shower head and two taps connected *Bath spout and two taps connected *Laundry spout and two taps connected *Washing machine two taps connected *Kitchen sink - spout and two taps, waste connected ***Require help carrying vanity (900mm) down 8 stairs into Bathroom ***I will have all spouts and taps, but no waste pipes

Need to build some brick steps with sandstone treads into the wall opening pictured. Dimensions are approximately 1600(w) X 480 (h). A concrete pad was poured for these when the driveway was done. Will need to be two steps and roughly 600 deep. The wall was cut with a demo saw so the corner bricks will need to be replaced to build the return. I can supply cleaned face bricks though some commons may be needed for the inside.

We are in need to move the laundry taps down below the link as we are moving from a top loader to a front loader machine. Will also need to install laundry sink and tap - Due date: Flexible

A day worth of work in internal painting. A couple of doors, cornice, archs. A few touch ups. Paint supplied. Glenbrook Wanted to start ASAP.

I have a Hewlett Packard HP 42s calculator which beeps when the batteries are put in. a search on the forums shows that this seems to be caused by a loose ram chip. the fault has been checked against https://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/archv014.cgi?read=51373 and holding down the case on the back of the 5 key stops the beeping. it therefore seems to need the ram chip soldered back on.

Experienced labourer/landscaper etc required to cut & install sandstone caps onto existing retaining wall approx 30m in length. Sandstone caps already on site. Unsure of hours required so just using the budget as a guide.