Find an experienced concrete cutting contractor in VIC

Need small job concrete cutting done. Roughly two cuts about meter long each

I have a crossover which is no longer used. I am planning on replacing the concrete with garden beds and a sandpit and need someone to cut the concrete, break it up (which likely has reinforcing steel) and remove the concrete from site. Concrete area to cut along the fenceline is 6m length approx and 1.7m wide. Please include disposal in quote.

3 squares cut along wall for planting Boston Ivy approx 50 x 50

Concrete cutting in backyard with careful cutting around pipes. Easy access for machine Approximately 20 liner mtrs

Scope is in 3 parts: 1. Cut 10 concrete cuts 2.6m long in driveway and remove about 1.3m2 of rubble so I can insert turf strips. (I need to make the driveway permeable to meet council regs). 2. Backfill a trench 4m x 150mm x 200mm with concrete so it can be tiled over. 3. Pour a small concrete slab 1.2m x 1.2m which will be tiled over.

Looking for someone with correct equipment (not just a Jack hammer) to cut 7 x gaps along our paving 2 bricks wide for us to plant along. We are unsure of concrete depth underneath bricks. Quote per hole (ie quote for 1 but will need to do 7) Location Ivanhoe.

I am Looking for someone to cut and remove approximately 300mm x 300mm concrete. It is to expose the termite treatment box at a property. It is already been cut with a 190mm angle grinder however it needs something bigger to cut as the concrete is probably between 100mm- 150mm thick. It has to be completely removed as well.

9.5 square meters of concrete paving slab cut and removed. Include in offer total price or square meter rate. Advise if have own equipment and if there is an additional charge if the paving slab is found to contain reinforcing. There is good access.

Cutting and removal of concrete tiles approx 1.5m by 1.5m. Concrete is the space under the fake turf in the photo

Need channel grate drain installed and connecting to existing drains. Can provide the drains... You will need to cut concrete and install 2 sides. 10m side and 6m side long.

Concrete cutting around 2 meter length to run new shower tray pipes to existing drainage network. And out floor cutting around 3 meter to connect new water class WC drainage to existing network. Expecting around 3 to 5 hour job.

Shower recess roughly 1 m x 1.5 need to cut down 60 mil for shower recess

We need laborer to cut concrete and dig as per images attached. Excavation area dimension 500x500x1500 mm Includes removal of rubble from site.

Looking for quotes, obviously will cost more than $5 Outdoor concrete slab Used to host a hot tub Now want to remove Is continuous under the deck

I need approximately a 15 metre straight cut through concrete on a driveway. Only one cut required and all rubble to be left there ….no removal . I need an experienced operator with a demo saw or upright concrete cutting machine to complete job. One cut only and it must be straight….concrete depth approximately 100mm Very flexible can be done anytime within 1 week. Only experienced professional people need apply

I want to cut 2 holes in wallan driveway- you will require a demo saw and maybe jack hammer and shovel. - will be approx 1 hour job I think

Concrete cutting 3 x 80mm deep channels in slab. 1 @60cm long x 20cm wide. 1@ 140cm x 20cm wide, 1 @ 170cm x 20 cm wide. Need to cut several cuts then jack hammer out to the 80mm depth. House in Cheltenham, Melbourne. Ready now and need done by 30th April

I need some concrete cutting / channels around sides of my house to allow water to drain , around 30 m in total , 50 mm deep 100mm wide , I will add some small grates and tie into down pipes later

Excess concrete footings from factory in back yard need cutting and removing. Approx 7.5m wide x 40cm deep. Footing excess needs to cut as close to concrete wall as possible. Also need to cut down the square concrete drain to ground level. No side access - all tools etc will have to come through the house so care must be taken.

Cut concrete 9.4m with 2 cuts approx 200mm apart to allow grate install