Find an experienced concrete cutting contractor in QLD

Cutting through a concrete floor in a large garage for plumbing layout.

I need around 80 meteres cut with the saw concrete is 150mm thick will need the big saw

Cut around 9 meters of concrete on a slab and 4 meters retaining wall.

Needing someone to come cut the top of this concrete beam (in between the rollers) so it can be knocked down. We can knock it down just needing the concrete cut done.

Looking for someone experienced to install approximately 6 metres of drainage along the side of my house. The job will likely involve: * Cutting and removing existing concrete (approx. 6m) * Excavating as required * Installing suitable channel drainage / drainage pipe * Ensuring correct fall for water drainage * Connecting to the existing stormwater system if suitable * Removing waste * Making good / repairing the concrete after installation Please provide a quote including labour and materials.

Cut a straight cut 5 to 8 mm wide into concrete along the edge of a wooden deck - 3300 mm long- up to 100 mm depth ( no steel to cut ) Purpose is to separate / isolate concrete slab from the deck Grind high spots & trowel marks off a concrete surface - by 3300 mm by 600 mm - in front of the entrance deck - Leaving a smooth surface suitable for subsequent coating Grind a small area of concrete 600mm by 400 mm & patch 150mm section of an expansion joint- Leaving a smooth surface suitable for subsequent coating

I need someone with a demo saw / concrete saw to cut a notch into a concrete floor at Palm Beach. - Length: approx 2 metres, straight line - Width: approx 50mm - Depth: approx 30mm (deep enough to seat electrical conduit - happy to take your advice on site) - Purpose: laying electrical conduit into the slab Please bring your own saw, blades, water or dust extraction. Wet cutting or dust-controlled cutting preferred, as this is inside a finished space.

I'm looking for an experienced person with a concrete saw to cut a straight line in the concrete alongside my house in Zillmere. Job details: Cut a straight line approximately 11 metres long. The cut needs to be 450 mm (45 cm) from the house wall along the entire length. Cut only – do not remove or demolish the concrete. The cut should go through the concrete down to the soil to allow the concrete to be removed later.

We need to make our side concrete path 25mm narrower to accommodate a new retaining wall. Looking for someone to make a single cut 10m long along the edge of the concrete path. Concrete does not need to be removed, we just need it cut so then we can break it up and remove it.

Cut and remove a concrete slab. 6mx6m x100mm thick with reinforcing. Access to site is through a carport 2.3m high.

Cut and remove excess slab around pool approx 6.5sqm, would like cut to be 100mm or less from pool edge, please see photos, thanks

Looking for someone ASAP this morning to cut concrete and jackhammer 2m of concrete for a toilet relocation. Saw and jackhammer supplied.

Looking to get 60sqm of a 150mm thick concrete driveway cut. I can arrange a concrete skip if required to assist in the disposal or happy for you to manage the disposal.

We have a downpipe that was not connected properly under the pool concreting and is leaking through the house brick wall. Need to cut away the concrete surrounding the downpipe so a plumber can then fix the pipe fitting.

2* 80cm cuts through 125mm concrete

cut existing concrete beside patio/fence • install channel drai • connect into existing backyard stormwater drainage • fix pooling water issueduring rain Have dug put piled dirt from the current drain which flows when the water hits the pipe level in that drain

I need someone with a concrete saw to cut through 2 or 3 concrete post foundations. Foundations are approximately 400mm × 200mm

One concrete cutting 6m long.

Concrete Slab: 3.8 m x 2.28 m need cutting up only.

I need to core a 150mm-200mm diameter hole in a reinforced concrete slab that is 100mm thick. The hole should be as close as possible to the fence sleeper. The purpose of the hole is to provide an opening to install and 50mm in-ground gate post. The surrounding concrete should not be damaged.