Find an experienced concrete cutting contractor in NSW

Concrete Cutting and Channel Drain (install or no install quotes please) - Drain 7m straight - 14cm Wide

Need a drain channel cut on a concrete driveway . 8 metres long around 6 inches wide and deep.

Located at my backyard. The concrete is 3.5m long and 1.35m wide. It is the concrete underneath the water tank. The water tank has been removed. How much would it be to cut it into pieces and move them to the bin? I can provide the bin.

Located at my backyard. The concrete is 12.5m long and 4m wide. From the step up, 9m long and 5m wide. Should all be about 150mm deep. Would like this done ASAP.

We need a long narrow strip of concrete removed for some electrical work that needs to be done. Must be able to cut the concrete right up to the house. 665cm long line that is 13cm wide. This then needs to meet another cut to make an L that is 110cm long (also 13cm wide). Small third cut maybe required to take this back to the wall (less than 5cm).

I need help to provide me with a quote to provide the following services so I can repair my broken sewer line: 1. Concrete cutting of 100mm depth of concrete. Total length c. 7 metres, and width of 400mm to be cut.  Width of the side lane way is c. 1.4 metres so should be able to fit machine in the lane way.  2. Re-concreting (post new sewer line installation). I will need Re-concreting services of 100mm depth of concrete for this 7 metres long and 400mm width trench to be re-concreted.  Please include quote for removal of the old concrete.  Budget $100 per linear metre. Many thanks.

I recently posted this but wasn’t clear enough about what was required. Concrete wall cut as per photos 200mm deep, Approx 600 high Approx 600 horizontal Take offcuts away Vacuum dust and sludge and take away. Tight location next to pool so only suitable for hand held cutter.

Concrete cut to make a drain

I need to dig a 10m trench (30cm wide and 30cm deep). There is a trench but it will need to be widened ) made a little deeper. Need to concrete cutting / sandstone cutting / dig out small bit of dirt. Can leave all dirt and concrete.

I have a suspended concrete slab approx. 150mm thick with galvanised corrugated steel. Require a quote to cutout an area of 21.5sqm We are installing a pool, the cutout area is a portion of the patio slab.

How much for 3 straight cuts into 100mm concrete, 1 x 6m, 2 x 7m, location is Seven Hills

Concrete cutting to allow for the installation of approx 10 lineal meters of drainage and a pit as per pictures.

I have a small 10m strip of concrete that needs to be tidied up with a concrete cutter

Cutting concrete of foot path of frontage 4x3.5 m with excavator

House extension and granny flat build Requires 52 pad footing and some concrete cutting.

Cut out 2-3 doors ways And 4-5 niches  needed tomorrow ignore budget - place your offers.

Concrete cutting and jackhammering an entrance to a shop to remove a step that is 100mm high and ramp the concrete over 1-2 metres. Opening is 1.8m wide

I need to demolish 4m x 2m of concrete patio from my backyard. The concrete is 100mm thick, and 150mm thick where there are tiles. The edges of the concrete goes down to 200mm thick(refer images) and a further 100mm to the side and down, thus the edges will require a jackhammer to be removed. Please note that the access is narrow so no heavy machinery cannot come in, will need to be done by hand using a concrete/ring saw and a jackhammer. Please quote pricing for removal of the concrete as well.

I have a Concrete cutting job in Kelyville area. It is around approximately hundred linear meter how much you charge per meter. These are concrete stairs that need to be cut. Best prices pls

I’m after someone who can cut a hole in this wall in order for me to install a garage door. The cut out needs to be approximately 2.5 wide x 2.3 high. All rubbish can be left on site, It’s a besser block wall. Easy access