Find an experienced chair repair pro in Gold Coast

We have two wheelchairs that need a slight fix: 1. One wheelchair needs a right motor replaced, which is quite easy. Take the wheel off, put the motor in place, and put the wheel back on. The other wheelchair just needs the computer replaced, which is not internal, it's just on the side of the wheelchair. So nice and easy, just replacing it and re-running the wires. Two quite easy jobs.

Need someone who can build a flat pack chest of draws and 4 chairs

My outdoor table needs a makeover. A sand and restain or varnish. Work required would include the table top, bench seat top and the 4x chair arms - the bottoms of all the above is metal so it’s just the tops required. Tools and varnish required.

A children’s table and chairs to please be put together :)

Looking for someone to build a flat pack for me cause I hate them

Build an IKEA desk and chair.

Install mounting for hammock chair into concrete ceiling. I have following Installation Instructions For Concrete • Drill an 80 mm deep hole using an 8 mm masonry drill bit. • Hammer the bolts into the anchors. Be careful not to damage the threads. • Tighten the screws with a 13 mm wrench to a torque of approx. 15 Nm I have the fixing hardware here ( see photo attached).

build a chair (swivel chair)

The rollers stop moving when they go to the bottom of the chair.

Needing to hire 25 white chairs

construct office desk and office chair

I need the varnish removed from 3x dining chairs (excluding the seat). I’d prefer it was sanded back and no varnish stripper used. The task must be completed at your premise. I will drop the chairs off and collect them. First image is the current colour. The second image is how the chairs will come without a seat. Note the chairs do not pull apart any further than this.

I have an office table and chair that I need assembled. The components are still in the box. Need this done soon

We just purchased a boardroom table and 8 office chairs for our office. Need the boardroom table and 8 office chairs set up. Looks like an easy install.

I have a set of bar stools (3 total) with metal legs that are slightly too tall to fit comfortably under my kitchen island. I need each chair leg cut down evenly by approximately 3-5cm keeping the stability and finish intact. The chairs have slim, round metal legs with black powder coating. I’d prefer someone with experience cutting and finishing metal cleanly, so the end result looks neat and legs are even. Wanting to put little black rubber boots or stoppers on bottom to give it a clean look.

We have a loose dining chair that we would like secured and fixed please for $75. Back rest is wobbly.

I have 2 things that need to be assembled. - tommy swiss gas lift storage bed frame - 1x pago radar chair I will need it done on Tomorrow, Saturday, May 10, between 11:30AM-3pm. Pics attached. Please let me know if you are keen.

Sand and varnish table and chairs. I will supply the sander, discs and varnish. It will need 3 coats after a good sand.

Put together ikea desk and chair

Repair - lost some screws on the seat panels 4 x folding vintage garden chairs and revarnish.