Find a local Tasker to replace your engine in QLD

4 cylinder engine out of a forklift needs a clean. The engine is pulled apart, just needs thoroughly cleaning in preparation for rebuild. Tools and chemicals provided. Other ongoing odd jobs also available for the right person.

I have an old Land Rover 3.5v8 County 110. I’ve pulled the old engine and have a low mileage replacement, that has sat under covers for years. I’m looking for an older guy with experience in Rover v8s to give me a hand to refurbish the engine and reinstall it into the car. I have most of the tools and parts needed.

need a new i30 hyundai 2.0 L petrol engine. Take old one out and put a new one in.

Why my 2012 ranger pings under load. Engine light is on. Seems like the ecu had put the vehicle into sluggish mode. Because of the ping.

I have a virago 250 with some crappy black paint on the engine from the previous owner. I would like the paint stripped off Must be mobile and have own equipment

- 2014 Toyota Corolla (pictured) - Engine swap with 60,000km - Supplying all required associated needs (spark plugs, water pump etc.)

My 2014 Ford Fiesta engine light came on last night and is flashing id like a diagnostic

I have a Rolls-Royce B60 Engine thats started foulung plugs really fast. need to work out if its timing or carbs. Im after someone with some experience on similar engines.

Need someone hands-on with petrol engines to partially disassemble a 2016 Holden Cruze 1.8L engine (engine stays in car). Work involves removing cooling, intake, ignition, exhaust, head, timing, sump, and piston assemblies to hone cylinder walls, then reassemble with new piton rings and others that would be replaced in this type of re-assembly. Parts & gaskets supplied. Springwood location. Please briefly describe similar work you've done. The vehicle is located on level driveway in front of house. Nose of the vehicle facing the street for easy access. EDITS: If this is a rebuild, best to rebuild engine in a controlled environment: I understand the ideal nature of things. The effect may be an engine rebuild, but that is not the purpose. I have the skills to carry out the above task, but I currently do not have any time, hence the post. Objective is to restore compression in the cylinders, so, just a hone, replace rings, put the pistons back in with new con-rod bearings, re-assemble everything else, replacing gaskets. Resale value of these cars is driven to the ground by the reputation these have. Bought it as a daily driver until I can get a better daily driver, but ran in to troubles, so trying the make the best of a bad situation. Thanks again, but I am not in an ideal situation to do an ideal rebuild.

Need two crank cases vapour/soda blasted off a 1979 XL185. I can drop off to a location if needed

The car ran off the side of a driveway and the engine got pushed up and broke the engine mount so I need to find someone that can fix it or replace it so I can get the car back to Brisbane

2011 navara engine needs replacing. I have replacement engine

Looking for a qualified, licensed mobile mechanic to perform a diagnostic inspection on my 2006 Hilux 4.0L V6 4x4 .The engine recently overheated from a water pump leak and is now running rough with a ticking noise. My dad did a basic compression test and found one cylinder has low compression. The top end of the engine is currently half-disassembled (valve covers and intake plenum are off). I need a professional to come out to my garage to perform a Cylinder Leak-Down Test and use a Borescope Camera down the low cylinder. To determine if the low compression is just a blown head gasket, or if there is More damage to the cylinder walls or pistons Thanks Kyle

The engine was put upside down, does not start Most likely needs new spark I come transport it anywhere to you

1. OBD-II Diagnostic Scan. 2. Inspect engine to pinpoint source of the noise. 3. Repair the Fault If major repair is needed, cost will be seperate.

Looking for a mechanic experienced with these cars. Will be installing an SR20DET with five speed box into S13 rolling shell. looking to get it done across a few days and need guidance and assistance in getting everything right.

Hey everyone, I need someone install the rear engine mount for 2018 Ford Custom I already got the part, Car already lifted. I just hurt my arm so i cant do it anymore. I remove old one.

Hi! Looking for an auto electrician to help me hide a cable in my car. I got a DJI Power 1000 Mini portable power station for camping. It comes with the DJI Power Car Battery Charging Cable (5m). One end has alligator clamps (will stay on the car battery permanently). The other end has the SDC plug that I want accessible in the boot. I need: - Clamps secured to the battery (not dangling) - Cable hidden through the firewall and along door sills — no drilling - The SDC plug end neatly mounted in the boot Car: 2024 Ford Everest Sport I'll bring the cable, you bring cable ties / clips.

Recently brought a new Ute before had it serviced running well now overheats up hills, I want to get a diagnosis and possibly bleed coolant incase there’s an airlock. Need someone with abit of know how after 4:30pm today.

I have 2 cars engine and tramsmission from donor car to be removed and installed in other car after removing engine and tramsmission from it