Light Bar Installation Jobs in Ipswich

Browse through over 500 Light Bar Installation Jobs.

See what you could earn

$0

per month

Based on average light bar installation task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Light Bar Installation tasks in Ipswich

Check out what tasks people want done near you right now...

Flat pack storage boxes 3 medium 2 small Plastic light weight Bring own tools, drill, Allen key Based on House boat Assemble up a ladder top deck

Thorneside QLD, Australia

Sun Nov 08 2026

27 minutes ago

Open

Hi could someone install piegon net around solar panels? I can provide net from the Bunnings. Just need labour work Its a townhouse. I have 10kw system. Thanks :)

Toowoomba QLD 4350, Australia

Sun Nov 08 2026

39 minutes ago

Open

Looking for meticulous, highly experienced painter/handy tradie to restore, prep & stain multiple outdoor timber features on our premium property. Since this timber sits directly adjacent to high-end finishes (stone cladding, glass balustrades, tiled spa shell & composite mod-decking), extreme attention to detail and rigorous masking/protection are strict requirements. Scope of Work: 1. 6 Sets of Timber Stairs: Spot treat weathered patches with a chemical cleaner, light sand & stain (treads and risers). 2. Curved Slatted Batten Screen: Light wash, sand & precision stain (requires careful brushing/rolling between gaps from both sides). 3. 7 Vertical Columns & Surrounding Ledges: Light sand & stain. 4. Spa Coping: Deep prep & stain the timber frame directly surrounding the spa. Job Requirements: • Rigorous Protection (Crucial): Must spend adequate time using premium painter’s tape and drop sheets. Absolutely zero overspray, splashes, or chemical runoff is permitted on the stone walls, glass fencing, tiles, or composite decking. • Preparation: Use supplied timber cleaner on the weathered steps/coping to strip the grey dead cells and open the grain. Give all surfaces a uniform light sand so the final stain blends evenly between the weathered and unweathered sections. • Coats: Apply 2 coats of premium timber oil in a Merbau/Spotted Gum tone to match our adjacent mod-deck). Materials & Tools: • I will supply: The chemical timber wash & the premium timber stain/oil. • You must supply: An extension ladder capable of safely reaching the second story columns, precision sanding equipment, scrubbing brushes, high quality painters tape, protective drop sheets & application tools (brushes, mini rollers, trays, pads) Please view the attached pics to see exact layout and scale. In your offer, please confirm your experience working around sensitive surfaces like stone and glass. Other than this there are 2, 3, 4 & 6 tread stair cases of which only the 2 tread is weathered.

Mount Cotton QLD 4165, Australia

Sun Nov 08 2026

44 minutes ago

Open

I have a Concord Wireless HD Surveillance System with an 8-channel NVR and 1TB storage. I’d like three supplied cameras installed around the front of my house/front yard. The job includes: * Mounting and aiming the three cameras * Neatly securing and weather-protecting their power leads * Setting up the NVR indoors and connecting it to my internet/router * Pairing the cameras, checking recording and motion detection, and helping set up mobile viewing * Testing each camera before finishing Please bring your own ladder, drill and suitable mounting materials. Please check the camera power-lead lengths and outdoor suitability before mounting. No new power point or mains electrical work is included; if that’s needed, please tell me so I can arrange a licensed electrician. Please let me know your experience installing wireless CCTV systems and whether you’ll need anything else from me.

Kallangur QLD, Australia

Sun Nov 08 2026

about 1 hour ago

Open

We need an electrician to replace our kitchen oven - Brand: Technika Model: BG8SS-5 On Wednesday or Thursday. Install new oven and dispose the old oven.

Yarrabilba QLD 4207, Australia

Sun Nov 08 2026

about 1 hour ago

Open

Looking for someone to improve drainage along a narrow strip on the side of our house. The area is approximately 20 metres long and 20 centimetres wide, currently filled with rocks and some weeds. Water sometimes collects here, so we would like drainage installed along the full length to allow it to drain away properly. Work to include: * Remove existing rocks and weeds. keeping the rocks aside for reuse. * Supply and install a suitable drainage pipe or system along the. Photos attached. Located in Gumdale.

Gumdale QLD 4154, Australia

Sun Nov 08 2026

about 1 hour ago

Open

I need two Savage Tech MOLLE side storage panels (one left, one right) fitted inside the tub of my 2025 GWM Cannon Ultra. I'll supply the panels and all the included hardware. What's needed: - Bolt each panel to the factory threaded holes in the tub - Drill and fit two extra holes per panel (4 in total) using nutserts - Take care with the spray-in bedliner and seal any holes you drill so water doesn't get in - Tidy up when finished You'll need your own nutsert tool and drill. The installation guide is on the Savage Tech product page, and the video I'm working from is here: https://www.youtube.com/watch?v=8VBQeSTgYxY The ute has an Akuma roller shutter fitted. Please check the panels clear the shutter rails before drilling anything. I can attach a photo of a panel fitted in the same tub.

Wilston QLD 4051, Australia

Sun Nov 08 2026

about 1 hour ago

Open

I'm looking for an experienced handyman to complete some installation work at my property. Scope of work: Install 2 toilet paper holders (one on tile and one Gyproc ). Install 4 towel holders/rails (drilling into bathroom tiles). Install 1 bathroom mirror. just the bracket on tile, no power connections is required. Install 9 roller blinds. I am not sure if its fitted or need cutting to size. I don't need tax invoice. Please quote your cost per hr , just need to connect to a reliable person with reasonable price.

Zillmere QLD 4034, Australia

Sun Nov 08 2026

about 2 hours ago

Open

Install three sets of s-fold curtains. Drill required. Straight forward job, just don’t have the time to do it.

QLD 4355, Australia

Sun Nov 08 2026

about 3 hours ago

Open

Browse all tasks

Last updated on 8th Nov 2026

Unlock new income opportunities in Ipswich

Explore light bar installation related jobs and discover your financial opportunities

Type of light bar installation job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Mechanic	$360	$900	$1,260
Brake Pad Replacement	$334	$835	$1,169
Head Unit Installation	$420	$1,050	$1,470
Oil & Filter Change	$280	$700	$980
Car Aircon Regas	$390	$975	$1,365

*Based on average light bar installation task prices in Ipswich. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

We've got you covered

Whether you’re a posting a task or completing a task, you can do both with the peace of mind that Airtasker is there to support.

Airtasker’s insurance cover