Carpentry Jobs in St James NSW

Browse through over 500 Carpentry Jobs.

See what you could earn

$0

per month

Based on average carpentry task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Carpentry tasks in St James NSW

Check out what tasks people want done near you right now...

Provide 2 x white melamine shelf for medicine bathroom cabinet. Size is 47 cm wide by 16 cm deep. Need to use standard 16mm think melamine with edge banding on front and two sides. Deliver to Windsor VIC

Sun Oct 11 2026

about 1 hour ago

Open

Hey - I’m looking for a carpenter who can build a behind the sofa table. Ideally a light wood with varnish. Installing a power outlet would be great but not essential - thanks! Please see example photos Dimensions: 300cm length (total) in two halves. 67cm height and around 20cm width

Sydney NSW 2010, Australia

Sat Oct 10 2026

1 day ago

Open

Custom walnut-finish drinks cabinet Looking for someone to build a drinks cabinet similar to the attached image. Size: 1,000 W × 450 D × 900 H mm, including legs. Dark walnut finish, fluted doors, brass-tone handles, and an open centre with a hanging wine-glass rack and bottle storage. Quality engineered board is fine; solid timber isn’t required. Shipping to Pakenham, VIC. Please quote materials and labour, estimated timeframe, and any delivery costs. Potential for repeat orders if the quality and pricing work wel

Fri Oct 09 2026

1 day ago

Open

We have 2 tables and 2 wall hung vanity cupboards we would like remade into wood or wood veneer. The tables will have a stone top (25mm overhang at the front and 6mm overhang either side stone snd basin already purchased). The wall hung vanities sit approximately 150mm below the table. The table legs are slightly concave at the top and taper to the floor. Dimensions Tables 1 x L1800 x w 550 x h 780 - 2 holes needed 1 x L 1400 x w 500 x h 780 - 1 hole needed Vanity cupboards 1 x L1400 x w 420 x h 300 - 2 electrical connections either end and holes for plumbing 1 x L110 x w 420 x 300 1 electrical connection on left hand side and hole for plumbing. We would like quotes. We have originals for inspection if needed. Questions welcome. Dimensions available.

Fri Oct 09 2026

2 days ago

Open

Might be a long shot, but I'm looking for quotes from people who know how to make furniture out of wood to make something as close as possible to the wall-mounted desk in the image attached Would need to be under 90cm L and maybe around 45 cm D when fully extended. Flexible on material etc as long as it would look similar. Please send over a quote + timing if this is something you think you can do :) Located in Sydney

Sydney NSW 2000, Australia

Fri Oct 09 2026

2 days ago

Open

We're a cabinetry installation business based on the Gold Coast. We're looking to connect with experienced cabinetmakers and cabinetry installers interested in regular ongoing subcontract work. We have a variety of projects including kitchens, laundries, wardrobes, vanities and custom cabinetry installations. **This $10 task is for a brief introductory phone discussion** to chat about your experience, availability, rates and potential opportunities to work together. We're hoping to build relationships with reliable, experienced installers who take pride in their workmanship. If you're interested, please make an offer and briefly let us know about your installation experience. Looking forward to chatting!

Fri Oct 09 2026

2 days ago

Open

Create 3 wooden box as a cover for sunscreen lotion bottle. Please see photos for measurement and idea. Wood and supplies to be supplied by tasker.

Thu Oct 08 2026

3 days ago

Open

bedroom cupboard joinery - 3.7m approx wide - rattan inlay, shelving and internals, see image for two ai generated options

Surry Hills NSW 2010, Australia

Mon Oct 05 2026

5 days ago

Open

Hi, I need an experienced cabinet maker or joiner with a professional workshop setup to fabricate 5 cabinet doors and 1 side panel. This job must be completed off-site at your workshop and delivered back finished. The Design Setup (High Attention to Detail Needed): • Face & Reverse: The front laminate sheet and the back laminate sheet are different colours. • Edges: Each of the four edges on the doors/panel will feature a different colour ABS edging (e.g., matching the face, reverse, or specific accent borders). Precise attention to detail is required to ensure the correct edging goes on the correct side. What needs to be done: 1. Supply Substrate: You must supply the 16mm Moisture Resistant (MR) MDF core sheets. 2. Pick Up Materials: Collect the raw materials from my location in Seaford Vic 3. Laminate Pressing: Glue and press the laminates flat onto both sides of the 16mm MR MDF core using proper workshop pressing equipment (no air bubbles or telegraphing). 4. Precision Cutting: Cut the sheets cleanly down to the final sizes without chipping the laminate. 5. Multi-Colour Edge Banding: Apply the specific ABS edging variations to each designated border and trim flush. 6. Delivery: Drop off the 6 completed, finished pieces to my address. Approximate dimensions of finished pieces: • 5 x Doors: Roughly 60cm x 80cm each • 1 x Side Panel: Roughly 60cm x 80cm What I will provide: • 2 x Large sheets of laminate (1.8m x 3.6m each — two different colours) • All required rolls of ABS edging (in the different colours needed) What you must have/supply: • Supply of the required 16mm MR MDF sheets. • Commercial workshop setup (cold/hot press, precision panel saw, and edge-bander/trimmer). • Transport to pick up the 1.8m x 3.6m sheets and deliver the finished doors safely. Please outline your experience with custom laminate work and your estimated turnaround time in your offer. Thank you!

Sun Oct 04 2026

7 days ago

Open

Browse all tasks

Last updated on 11th Oct 2026

Discover your earning potential in St James NSW

Earn money with every carpentry task

$760

per week

1-2 tasks per week

$1,900

per week

3-5 tasks per week

$2,660+

per week

5+ tasks per week

$3,291

per month

1-2 tasks per week

$8,227

per month

3-5 tasks per week

$11,518+

per month

5+ tasks per week

$39,520

per year

1-2 tasks per week

$98,800

per year

3-5 tasks per week

$138,320+

per year

5+ tasks per week

*Based on average carpentry task prices in St James NSW. Actual marketplace earnings may vary

Join Airtasker

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Carpentry Taskers in St James NSW

meet
German V
12 years on Airtasker
- St James NSW
4.9
Overall rating
166 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
183 tasks
meet
Mark M
11 years on Airtasker
- Lilyfield NSW
5
Overall rating
161 reviews
99.46%
Completion rate
The percentage of tasks successfully completed by the Tasker
184 tasks
meet
Ronen S
8 years on Airtasker
- Randwick NSW
5
Overall rating
651 reviews
99.87%
Completion rate
The percentage of tasks successfully completed by the Tasker
763 tasks
meet
Craig I
7 years on Airtasker
- Engadine NSW
4.6
Overall rating
110 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
141 tasks
meet
David S
4 years on Airtasker
- Zetland NSW
4.8
Overall rating
297 reviews
99.73%
Completion rate
The percentage of tasks successfully completed by the Tasker
369 tasks
meet
Tangaroa T
2 years on Airtasker
- Rooty Hill NSW
5
Overall rating
131 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
163 tasks
meet
Ian K
2 years on Airtasker
- Sydney City CBD NSW
4.9
Overall rating
260 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
344 tasks
meet
Warren R
5 months on Airtasker
- Sydney City CBD NSW
5
Overall rating
18 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
22 tasks