Appliances Jobs in Redbank Plains

Browse through over 500 Appliances Jobs.

See what you could earn

$0

per month

Based on average appliances task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Appliances tasks in Redbank Plains

Check out what tasks people want done near you right now...

I have two faulty 80v kobalt batteries that will need charge for longer than 1 minute before they error. I have been told they might just need a 80v jump start or one individual cell may be imbalanced and need to be charged up. I do not have a multimeter these days nor a variable dc power supply

Mon Oct 05 2026

about 5 hours ago

Open

Breville BES870 semi automatic, c. 12 years old. Routinely descaled. Recently relocated back to Melbourne by sea freight. On filling up the machine I noticed leakage under pressure at the bottom of the machine below drip tray and a lack of group head pressure. The steam wand currently works normally. Heating elements all appear nominal. The machine has never been serviced as it has been reliably working until now with routine maintenance. Happy to consider reasonable quotes for diagnosis alone with repair to follow (quoted price is diagnosis and repair)

Sun Oct 04 2026

1 day ago

Open

My Rocket appartamento machine has a flow problem. The water flow stops when flashing or pulling a shot. It then restarts, like it has an air lock

Sat Oct 03 2026

1 day ago

Open

Washing machine is not working

Brisbane QLD 4301, Australia

Sat Oct 03 2026

2 days ago

Open

Seeking an experienced refrigeration or mechanical engineer to independently compare two contractor quotes for installing and commissioning propane (R290) heat pump chillers in the plant room of an office building in Belgium. Equipment: Enerblue and Carrier. Remote desk review only, no site attendance. SCOPE 1. Completeness of scope, inclusions, exclusions and likely variations 2. EN 378 compliance for A3 refrigerants: charge limits, ventilation and emergency extract, gas detection, pressure relief, safety interlocks 3. ATEX zoning (IEC/EN 60079-10-1) and suitability of electrical equipment within zones 4. Pressure and leak testing, commissioning and handover documentation 5. Compliance with manufacturer installation requirements (warranty risk) 6. Price reasonableness, programme risk and inspection/acceptance risks 7. Recommendation and clarifications to put to each contractor ESSENTIAL - Hands-on R290 or hydrocarbon heat pump/chiller experience in commercial buildings, ideally indoor plant rooms - Working knowledge of EN 378 and ATEX. AU experience (AS/NZS 5149, AS/NZS 60079) welcome if you can apply the EU equivalents - Clear report writing for a non-engineering reader DESIRABLE - Enerblue or Carrier hydrocarbon units - Tender comparison or independent review experience DELIVERABLES - Written memo (4 to 8 pages) with comparison table and red flag list - One hour video call CONFIDENTIALITY Quotes and project details released only after appointment and signing a confidentiality agreement. You must have no connection with any contractor, manufacturer or distributor involved. TO APPLY, PLEASE ANSWER 1. How many R290/hydrocarbon installs have you designed, installed or commissioned, and the largest charge? 2. Have you done or reviewed an ATEX zoning for a plant room? Brief example. 3. Which standards do you routinely work to? 4. Can you deliver within 5 business days of receiving documents? 5. Can you share a redacted example report?

Sat Oct 03 2026

2 days ago

Open

Blanko domestic coffee machine. O ring is worn and needs replacing. Where it seals with external milk canister. Clean as well

Fri Oct 02 2026

3 days ago

Open

Hi, I’m looking for a qualified washing machine technician to inspect and repair my washing machine. The washing machine is leaking water during use, and I need the source of the leak identified and repaired. I have not purchased any parts yet, so I would like the technician to diagnose the issue and supply and install any parts required. Could you please provide your call-out/diagnostic fee and an estimated total cost for the repair, including parts and labour? Please also let me know whether the call-out fee is deducted from the repair cost if I proceed with the repair. Thank you.

Redbank Plains QLD 4301, Australia

Fri Oct 02 2026

3 days ago

Open

Ryobi whipper snipper petrol pull cord is pulled out of it need put back in or replaced cord only by tomorrow or next few days

Thu Oct 01 2026

4 days ago

Open

Breville oracle touch dual boiler about 4-5 years old tripping the power once it has been used and turned off (cooling down) sometimes it has other issues like steam ward blows randoms, hot water drops random. Can you give me an idea on what it could be/cost and I will work out if I want to get it fixed or upgrade my machine

Wed Sep 30 2026

5 days ago

Open

Browse all tasks

Last updated on 5th Oct 2026

Discover your earning potential in Redbank Plains

Earn money with every appliances task

$390

per week

1-2 tasks per week

$975

per week

3-5 tasks per week

$1,365+

per week

5+ tasks per week

$1,689

per month

1-2 tasks per week

$4,222

per month

3-5 tasks per week

$5,910+

per month

5+ tasks per week

$20,280

per year

1-2 tasks per week

$50,700

per year

3-5 tasks per week

$70,980+

per year

5+ tasks per week

*Based on average appliances task prices in Redbank Plains. Actual marketplace earnings may vary

Join Airtasker

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Appliances Taskers in Redbank Plains

meet
Bradley F
1 month on Airtasker
- Redbank Plains QLD
4.8
Overall rating
16 reviews
91.3%
Completion rate
The percentage of tasks successfully completed by the Tasker
23 tasks
meet
Benjamin H
1 year on Airtasker
- Jimboomba QLD
5
Overall rating
309 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
353 tasks
meet
Guy R
6 months on Airtasker
- Griffin QLD
4.9
Overall rating
78 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
91 tasks
meet
Jake A
2 years on Airtasker
- Kallangur QLD
4.9
Overall rating
69 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
78 tasks
meet
Rehan L
9 years on Airtasker
- St Lucia QLD
4.9
Overall rating
1841 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
2068 tasks
meet
Paul H
8 years on Airtasker
- Capalaba QLD
4.9
Overall rating
259 reviews
99.67%
Completion rate
The percentage of tasks successfully completed by the Tasker
306 tasks
meet
Steve T
2 years on Airtasker
- Ripley QLD
5
Overall rating
43 reviews
95.45%
Completion rate
The percentage of tasks successfully completed by the Tasker
44 tasks
meet
Alan N
4 years on Airtasker
- Toowoomba Central QLD
4.9
Overall rating
133 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
156 tasks