Appliance Installation Jobs in Sydney

Browse through over 500 Appliance Installation Jobs.

See what you could earn

$0

per month

Based on average appliance installation task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Appliance Installation tasks in Sydney

Check out what tasks people want done near you right now...

I need someone to remove my old ranged hood and install new one

Chippendale NSW 2008, Australia

Fri Oct 09 2026

2 days ago

Open

Kärcher cordless floor cleaner – inspect and repair at home I’m looking for an experienced appliance repair technician to inspect my Kärcher cordless hard floor cleaner, believed to be an FC 5. The battery indicates that it is fully charged. When I press the power button, the rollers turn for approximately two seconds, then the machine shuts down completely. The technician will need to attend my home in Woolloomooloo, Sydney, to diagnose the fault. I would prefer the repairs to be completed at my home wherever possible. My initial budget is $120 for the visit, diagnosis and any minor repair that can be completed during the appointment. Please quote separately for any replacement parts or additional labour and obtain my approval before proceeding. Please include your relevant experience with Kärcher floor cleaners or similar cordless appliances, and confirm what your offer includes. Photos of the machine are attached. Timing is flexible and can be arranged.

Sydney NSW 2011, Australia

Fri Oct 09 2026

2 days ago

Open

Seeking an experienced refrigeration or mechanical engineer to independently compare two contractor quotes for installing and commissioning propane (R290) heat pump chillers in the plant room of an office building in Belgium. Equipment: Enerblue and Carrier. Remote desk review only, no site attendance. SCOPE 1. Completeness of scope, inclusions, exclusions and likely variations 2. EN 378 compliance for A3 refrigerants: charge limits, ventilation and emergency extract, gas detection, pressure relief, safety interlocks 3. ATEX zoning (IEC/EN 60079-10-1) and suitability of electrical equipment within zones 4. Pressure and leak testing, commissioning and handover documentation 5. Compliance with manufacturer installation requirements (warranty risk) 6. Price reasonableness, programme risk and inspection/acceptance risks 7. Recommendation and clarifications to put to each contractor ESSENTIAL - Hands-on R290 or hydrocarbon heat pump/chiller experience in commercial buildings, ideally indoor plant rooms - Working knowledge of EN 378 and ATEX. AU experience (AS/NZS 5149, AS/NZS 60079) welcome if you can apply the EU equivalents - Clear report writing for a non-engineering reader DESIRABLE - Enerblue or Carrier hydrocarbon units - Tender comparison or independent review experience DELIVERABLES - Written memo (4 to 8 pages) with comparison table and red flag list - One hour video call CONFIDENTIALITY Quotes and project details released only after appointment and signing a confidentiality agreement. You must have no connection with any contractor, manufacturer or distributor involved. TO APPLY, PLEASE ANSWER 1. How many R290/hydrocarbon installs have you designed, installed or commissioned, and the largest charge? 2. Have you done or reviewed an ATEX zoning for a plant room? Brief example. 3. Which standards do you routinely work to? 4. Can you deliver within 5 business days of receiving documents? 5. Can you share a redacted example report?

Sat Oct 03 2026

8 days ago

Open

My Samsung washing machine (model WW75T504DTW/SA, 7.5 kg front loader) has a drum lifter/paddle that has come loose inside the drum. According to the parts diagram, the lifter is clipped at the front and screwed from the outside of the drum at the back, so the repair requires removing the tub/drum assembly to access and refit the screw. Looking for an experienced appliance technician to: • Replace the drum lifter (Samsung part DC66-00759A) or refit the existing one if it's undamaged • Check the tub for any loose screw or debris • Reassemble and test the machine Please include in your offer: • Your call-out fee and total estimated price • Whether you can supply the part • Your experience with Samsung front loaders Photos available on request.

Sydney NSW 2026, Australia

Thu Oct 01 2026

10 days ago

Open

Repair Fisher & Paykel DishDrawer – No Power Description Looking for an experienced appliance technician to diagnose and repair my Fisher & Paykel DishDrawer dishwasher. Model: DD60SCX9 Product: 81082-A The dishwasher was previously working normally but has suddenly stopped powering on completely. There are no lights, display, beeps or other signs of power. I have already: * Confirmed the wall power outlet is working using another device. * Tried the dishwasher on a known-working power source. * Confirmed the issue is with the dishwasher itself. Looking for someone who can diagnose the electrical fault and ideally repair it during the same visit. Possible causes may include the internal power supply, fuse, wiring, control board or related components. Please quote your call-out/diagnostic fee and let me know if you have experience repairing Fisher & Paykel DishDrawers.

Surry Hills NSW 2010, Australia

Thu Oct 01 2026

10 days ago

Open

Need to replace Recirculating robinhood rangehood. I’ve bought one exactly the same size as my current one however another installer said it needs to be installed 4cm higher so cabinet above it needs to have a shelf moved and doors shaved at the top and reinstalled. (I’ve been using the rangehood for years without an issue at the current height)

Alexandria NSW 2015, Australia

Mon Sep 28 2026

12 days ago

Open

Panel flashing white light, AI suggested troubleshooting completed without success

Centennial Park NSW 2021, Australia

Mon Sep 28 2026

13 days ago

Open

Surry Hills NSW 2010, Australia

Thu Sep 24 2026

17 days ago

Open

Hi there, I am looking for a qualified appliance repair technician to inspect, fix, and deep clean my washing machine in Maroubra. The machine has two major issues that started today: 1. Mechanical Fault: The spin cycle is running way too fast, feels completely out of control, and seems severely unbalanced. 2. Dirt/Sludge: My clothes came out dirty and stained today. It looks like it is either tracking in old sludge from a drainage block or leaking mechanical grease/rust into the drum. Requirements: - Please diagnose the spin/balance issue and provide a fix. - Once fixed, I would also like the machine thoroughly cleaned out (including the drum, seals, and filter) so it is safe to wash clothes in again. Please let me know your call-out and diagnosis rate in your offer. If any replacement parts are required (like shocks, pumps, or bearings), we can negotiate the cost of those once you have inspected the machine. Thank you!

Maroubra NSW 2035, Australia

Wed Sep 23 2026

18 days ago

Open

Browse all tasks

Last updated on 11th Oct 2026

Discover your earning potential in Sydney

Earn money with every appliance installation task

$310

per week

1-2 tasks per week

$775

per week

3-5 tasks per week

$1,085+

per week

5+ tasks per week

$1,342

per month

1-2 tasks per week

$3,356

per month

3-5 tasks per week

$4,698+

per month

5+ tasks per week

$16,120

per year

1-2 tasks per week

$40,300

per year

3-5 tasks per week

$56,420+

per year

5+ tasks per week

*Based on average appliance installation task prices in Sydney. Actual marketplace earnings may vary

Join Airtasker

Unlock new income opportunities in Sydney

Explore appliance installation related jobs and discover your financial opportunities

Type of appliance installation job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Appliances	$300	$750	$1,050
Washing Machine Repairs & Installation	$254	$635	$889
Dishwasher Repair	$346	$865	$1,211
Appliance Repair	$300	$750	$1,050
Appliance Installation	$310	$775	$1,085
Oven Repair	$370	$925	$1,295
Gas Fitters	$400	$1,000	$1,400
Cooktop Installation	$400	$1,000	$1,400
Stove Installation	$360	$900	$1,260
Gas Stove Installation & Repair	$440	$1,100	$1,540

*Based on average appliance installation task prices in Sydney. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Appliance Installation Taskers in Sydney

meet
David H
10 years on Airtasker
- Bondi Junction NSW
5
Overall rating
1144 reviews
99.85%
Completion rate
The percentage of tasks successfully completed by the Tasker
1331 tasks
meet
Milad B
9 years on Airtasker
- Merrylands NSW
5
Overall rating
529 reviews
99.67%
Completion rate
The percentage of tasks successfully completed by the Tasker
599 tasks
meet
Ricky B
8 years on Airtasker
- Moorebank NSW
4.9
Overall rating
2468 reviews
99.57%
Completion rate
The percentage of tasks successfully completed by the Tasker
3259 tasks
meet
Oleksandr C
7 years on Airtasker
- Marrickville NSW
5
Overall rating
1269 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
1476 tasks
meet
Elton S
4 years on Airtasker
- Brighton Le Sands NSW
4.9
Overall rating
308 reviews
99.72%
Completion rate
The percentage of tasks successfully completed by the Tasker
363 tasks
meet
Mike N
2 years on Airtasker
- Lansvale NSW
5
Overall rating
180 reviews
99.55%
Completion rate
The percentage of tasks successfully completed by the Tasker
222 tasks
meet
Soran E
1 year on Airtasker
- Lane Cove North NSW
4.9
Overall rating
64 reviews
98.59%
Completion rate
The percentage of tasks successfully completed by the Tasker
71 tasks
meet
Azizuddin S
9 months on Airtasker
- Greenacre NSW
4.9
Overall rating
178 reviews
98.67%
Completion rate
The percentage of tasks successfully completed by the Tasker
226 tasks