Light Bar Installation Jobs in Parramatta

Browse through over 500 Light Bar Installation Jobs.

See what you could earn

$0

per month

Based on average light bar installation task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Light Bar Installation tasks in Parramatta

Check out what tasks people want done near you right now...

I would like to install a linear 7 glass globes pendant in my dining room.

Eastwood NSW 2122, Australia

Fri Jun 19 2026

2 minutes ago

Open

We require the installation of a Eufy S4 NVR PoE 24/7 Security System, comprising two PTZ cameras and two bullet cameras on our single storey house. The installation must include good wire management to ensure a clean and professional aesthetic. **End to End installation required** Specifically, the camera placement should be as follows: * One PTZ camera positioned at the front of the residence. * One PTZ camera positioned at the rear of the residence. * One bullet camera positioned on the left side of the residence. * One bullet camera positioned on the right side of the residence.

Seven Hills, New South Wales

Fri Jun 19 2026

23 minutes ago

Open

Cost please to assemble one Costway Extendable Dining Table Hall Console Kitchen Bar Drop Leaf Natural

Granville NSW 2142, Australia

Fri Jun 19 2026

33 minutes ago

Open

2 door frames- one left side needs complete redo, one to patch, ceiling hole fixed, cornice replaced, toilet roll holder removal and install.

West Ryde NSW 2114, Australia

Fri Jun 19 2026

about 4 hours ago

Open

Office Furniture Assembly – Rydalmere Job Overview We require an experienced furniture assembler/handyman to assemble and install a new 4-person workstation and additional office furniture at our office. Location Ground floor office. Date & Time * Working hours: 9:00am – 5:00pm * All work must be completed during normal office hours. Scope of Work * Assemble and install one (1) new 4-person workstation supplied as a flat-pack. * Assemble up to four (4) office storage cabinets (sample images provided). * Some workstation components, including the drawer units, have already been assembled as shown in the supplied photos, reducing the overall assembly time. * Once the workstation has been completed, continue assembling as many of the office storage cabinets as possible before 5:00pm. Important Information * The workstation is supplied without assembly instructions. * Similar workstations from the same manufacturer are already installed in our office and can be used as a reference during assembly. * Photos of all furniture have been provided prior to commencement. Requirements * Bring your own tools and any equipment required to complete the work. * Ensure all furniture is assembled correctly, level, secure, and ready for use. * Remove and neatly stack all packaging upon completion. * Take reasonable care to avoid damage to office flooring, walls, and existing furniture. * Maintain a clean and safe work area throughout the installation. Completion Please allow the full period from 9:00am to 5:00pm to complete the workstation and assemble as many of the cabinets and bookshelves as possible. It is anticipated that the workstation will not require the full day, and we expect the remaining time to be used productively to complete as much of the additional furniture assembly as possible. If you require any further information prior to commencing the work, please let us know.

Rydalmere NSW 2116, Australia

Fri Jun 19 2026

about 4 hours ago

Open

Install Aqara U100 Lock. Will add pictures soon.

West Pennant Hills NSW 2125, Australia

Fri Jun 19 2026

about 4 hours ago

Open

Ground Floor (workshop area) • Clean front door (main entry) • Retouch paint on the door • Replace fluorescent light bulb • Clean kitchen cabinet and replace kick board • Replace adjustable door closer on Fire Exit door • Patch holes on the wall • Repair crack on the wall near toilet area • Remove paint and WHS floor marking tape on floor • General cleaning Level 1 • Patch holes and paint wall, classroom area and behind the door (stairs area) • Clean writing marks near the stair way • Patch holes on door and paint • Replace 6 ceiling boards • Carpet dry clean • Replace kitchen cabinet kick board • Replace fluorescent light bulb near the stairway

North Rocks NSW 2151, Australia

Thu Jun 18 2026

about 4 hours ago

Open

Run a pipe under the existing floor from the kitchen sink to the fridge space (opposite of sink) (distance is 3 m) and add a water point behind the fridge. Access for running the pipe can be from the house subfloor.

Winston Hills NSW 2153, Australia

Thu Jun 18 2026

about 7 hours ago

Open

Need to install 11 LEd downlights as a replacement and replace 2 downlights with decorative lights. I can supply the lights. Provide your offers as lump sum. Note- needs to be done on sunday. Existing hole 70 mm and requires enlargement to 90mm. Ceiling height first floor 2.9m No lights on staircase but on corridor and can be accessed.

Wentworthville NSW 2145, Australia

Thu Jun 18 2026

about 8 hours ago

Open

Browse all tasks

Last updated on 19th Jun 2026

Unlock new income opportunities in Parramatta

Explore light bar installation related jobs and discover your financial opportunities

Type of light bar installation job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Mechanic	$330	$825	$1,155
Head Unit Installation	$320	$800	$1,120
Oil & Filter Change	$300	$750	$1,050

*Based on average light bar installation task prices in Parramatta. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Light Bar Installation Taskers in Parramatta

meet
Minh ha N
5 years on Airtasker
- Brighton Le Sands NSW
5
Overall rating
1133 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
1306 tasks
meet
Yingwu J
8 years on Airtasker
- Kellyville NSW
5
Overall rating
825 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
892 tasks
meet
Michael Y
6 years on Airtasker
- Southbank VIC
5
Overall rating
439 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
486 tasks
meet
Maico L
7 years on Airtasker
- St James NSW
5
Overall rating
174 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
191 tasks
meet
Marwan H
11 months on Airtasker
- Beverly Hills NSW
4.9
Overall rating
143 reviews
97.87%
Completion rate
The percentage of tasks successfully completed by the Tasker
188 tasks
meet
Timothy roy R
2 years on Airtasker
- Cabramatta NSW
5
Overall rating
88 reviews
98.23%
Completion rate
The percentage of tasks successfully completed by the Tasker
113 tasks
meet
Rolly P
7 years on Airtasker
- Pennant Hills NSW
5
Overall rating
37 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
44 tasks