Driveway Repair & Installation Jobs in Ryde

Browse through over 500 Driveway Repair & Installation Jobs.

See what you could earn

$0

per month

Based on average driveway repair task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Driveway Repair tasks in Ryde

Check out what tasks people want done near you right now...

I'm installing new decking tiles, managed to pull out the old tiles from under the AC but the compressor is way too heavy for me to lift to install the new ones. Literally need someone to lift the unit for like 5 minutes. Limited parking, lift access to 8th floor, then two sets of internal stairs to the balcony. I see if I can find the weight on the unit in the morning but its pretty damn heavy.

St Leonards NSW 2065, Australia

Thu Oct 01 2026

about 7 hours ago

Open

I need to install Need to install a 32A outlet for my two phase board to charge an electric car. Install near meter box Need one twin outdoor light installed somewhere under the ground floor eaves in the attached photo. Need a 2 way switch one on inside and one on outside. I will supply the lights. You supply indoor and outdoor switch and an cabling and conduits. Location very close to meter box and some limited access available from roof cavity. Location near Epping NSW - Due date: Flexible

Wed Sep 30 2026

about 19 hours ago

Open

The garden shed 3m x 3m will be on the lawn at the backyard. The place is flat. The wheel barrow will easily make its way across the grass from the carpark to the shed place. Please provide a quote including all to need and even rubbish disposal as well.

Roseville NSW 2069, Australia

Wed Sep 30 2026

1 day ago

Open

Need someone to paint my ceiling , it’s a small space around 15sqm and the ceiling bulkhead . Ceiling is currently just plain white. I am hoping to paint it the same way in the photo above. I will provide the 3 paint shades: 1- ceiling paint ( light sand color ) 2- bulkhead paint ( brown stripe and lighter beige) If you could provide primer and paint tape, that would be great!

Ermington, New South Wales

Wed Sep 30 2026

1 day ago

Open

Removal of pile of construction rubble from backyard into a skip bin (skip bin located in the driveway - approx. 15m distance from the pile). Either a bobcat or a dingo will be required.

Ermington NSW 2115, Australia

Wed Sep 30 2026

1 day ago

Open

Hi there. I am looking for an experienced mobile auto upholsterer/trimmer to repair or replace the sagging roof lining (headliner) on my Ford Territory. The fabric has come loose from the backing board and needs a proper clean/scrape of the old foam and re-gluing with fresh foam-backed material. Vehicle: Ford Territory (SUV) Interior Specifications: Beige lining, no sunroof, but features an overhead DVD console that requires handling/trimming. Location: Thornleigh, NSW (private driveway space available for you to work) Timing: Flexible over the next 2 weeks Requirements: Please bring all necessary tools, specialised high-temperature automotive adhesive, and matching beige headlining material. Looking for a clean, professional job at a budget-friendly price. Please include your estimated price and availability in your offer. Thank you!

Thornleigh NSW 2120, Australia

Mon Sep 28 2026

4 days ago

Open

I’m looking for someone with the right saw/tools to help me cut Tasmanian Oak timber for a small DIY shelving project. I will supply the timber. The job is mainly straightforward, accurate cross-cuts. Planned cuts: 1 × Tasmanian Oak DAR board: 90 × 19 mm × 2400 mm Cut down to 1900 mm for the vertical spine 1 × Tasmanian Oak DAR board, 185 × 19 mm × 1.8 m — cut into 6 shelves, each approximately 25 cm long I’m looking for clean, square cuts with minimal tear-out. If possible, I’d also appreciate: light sanding of the cut edges advice on the best way to join the shelves to the spine I can bring the timber to you if you’re nearby, or happy to discuss options. Please let me know what tools you have and your availability.

Epping NSW 2121, Australia

Mon Sep 28 2026

4 days ago

Open

Objective: Reduce the high spot/apex at the top lip of the driveway to prevent vehicle undercarriages from scraping. Task: Grinding or shaving back a transition ramp across the full width of the driveway. Dimensions: The driveway is 2.5m wide and approx 75cm length of it needs to be ground to a dept of 20-30mm with a smooth taper. Finish: The ground surface must be finished smoothly without sharp lips or jagged aggregate edges. Material: The current surface is exposed aggregate concrete.

Sydney NSW 2075, Australia

Sat Sep 26 2026

6 days ago

Open

I'm looking for a handy person to install a black Rapidfence steel fence and gate on my concrete driveway in Pymble. All materials are supplied, so I'm after labour only. The fence: L-shaped run, about 7.6m in total 7 × Rapidfence 50 × 50 × 1300mm black steel flanged posts 4 × Rapidfence black steel flat top panels 1 × Rapidfence Balmain galvanised gate, To DO Set out and fix the 7 flanged posts to the concrete drive with galvanised concrete screws (drilling 28 holes into the concrete). Cut the 4 panels to length to fit between the posts. The cut ends need deburring, then a coat gal primer before fitting. Fix the panels to the posts with panel brackets and Tek screws. Hang the gate using pipe saddles top and bottom, so it's level and swings freely. Fit a D latch and a coil spring so the gate self closes & latches. I'm supplying: posts, panels, gate, brackets, concrete screws, Tek screws, D latch, pipe saddles, coil spring, masonry drill bits, and cold gal paint. You'll need to bring: a drop saw or angle grinder with a metal-cutting blade, impact driver, and general tools. I have a hammer drill you can use, or bring your own. It's an existing concrete driveway, so the holes must be kept at least 50mm from the slab edge. Experience cutting and fitting steel fence panels and hanging gates. Public liability insurance preferred. Timing: From Tues 29 Sept onwards. Budget: $500 The total fence length is appox 7.6m. Photos of the driveway and of the materials atached. Task Set out the fence line, then drill and fix the 7 posts plumb and in line (28 holes) 2–2.5 hrs Cut 4 panels, deburr and prime the ends about 1 hr Fit the brackets and panels 1–1.5 hrs Hang the gate, fit the pipe saddles, latch and spring, and adjust 1.5–2 hrs Total about 6–7 hours for one person Finish in one visit if you paint the cut ends first thing, the paint can dry while you fix the posts.

Pymble NSW 2073, Australia

Fri Sep 25 2026

6 days ago

Open

Browse all tasks

Last updated on 1st Oct 2026

Discover your earning potential in Ryde

Earn money with every driveway repair task

$734

per week

1-2 tasks per week

$1,835

per week

3-5 tasks per week

$2,569+

per week

5+ tasks per week

$3,178

per month

1-2 tasks per week

$7,946

per month

3-5 tasks per week

$11,124+

per month

5+ tasks per week

$38,168

per year

1-2 tasks per week

$95,420

per year

3-5 tasks per week

$133,588+

per year

5+ tasks per week

*Based on average driveway repair task prices in Ryde. Actual marketplace earnings may vary

Join Airtasker

Unlock new income opportunities in Ryde

Explore driveway repair related jobs and discover your financial opportunities

Type of driveway repair job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Building & Construction	$700	$1,750	$2,450
Shed Installation	$640	$1,600	$2,240
Pergola Installation	$580	$1,450	$2,030
Driveway Repair	$734	$1,835	$2,569

*Based on average driveway repair task prices in Ryde. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Driveway Repair Taskers in Ryde

meet
Michael D
10 years on Airtasker
- Pymble NSW
4.9
Overall rating
748 reviews
99.89%
Completion rate
The percentage of tasks successfully completed by the Tasker
892 tasks
meet
Andrew P
4 years on Airtasker
- Willoughby NSW
5
Overall rating
287 reviews
99.71%
Completion rate
The percentage of tasks successfully completed by the Tasker
350 tasks
meet
Edmond A
9 years on Airtasker
- St James NSW
4.9
Overall rating
244 reviews
99.68%
Completion rate
The percentage of tasks successfully completed by the Tasker
315 tasks
meet
Jimmy L
8 months on Airtasker
- Glenmore Park NSW
5
Overall rating
114 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
127 tasks
meet
Ahmad S
10 years on Airtasker
- West Pennant Hills NSW
5
Overall rating
802 reviews
99.77%
Completion rate
The percentage of tasks successfully completed by the Tasker
877 tasks
meet
Jean-paul (jp) N
11 years on Airtasker
- Marrickville NSW
4.7
Overall rating
104 reviews
99.18%
Completion rate
The percentage of tasks successfully completed by the Tasker
122 tasks
meet
Laith H
6 years on Airtasker
- Botany NSW
4.9
Overall rating
812 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
948 tasks
meet
Bradley B
6 years on Airtasker
- St Leonards NSW
5
Overall rating
107 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
119 tasks