Weld two horizontal 8 mm square steel bars across the bottom of each leaf of a two-leaf steel driveway gate, so a small dog can't squeeze through the wide V-gaps near the ground. This replaces the chicken wire currently tied to the gate, which comes off as part of the job. • Both leaves, 2 bars each: 4 bars in total. • Inside face of the gate (the property side, not the street side). • Each bar is one straight length laid across the inside of the gate and welded where it touches. No cutting into pieces to sit in line with the existing bars. The new bars • Material: 8 mm square solid mild steel bar, about 8 m in all (4 lengths of about 2 m). • Lower bar: 100 mm clear gap between the top of the gate's bottom rail and the underside of the bar. • Upper bar: 130 mm clear gap between the top of the lower bar and the underside of the upper bar. • Length: the full width of the leaf, about 2 m. Whether the ends stop against the outer frame or run over it is your call; the frame stands 4 mm proud of the zigzags, so ends that run over it need notching too. • Fixing: bar lies flat against the inside face of the zigzag bars. Weld it at every bar it crosses: 16 zigzag crossings, the 2 inner uprights and the 2 outer frame uprights. That is 20 welds per bar, about 80 in all. Tack welds are fine. Put every tack on the inside face, so it can't be seen in silhouette: a tack on the top or bottom edge of the bar looks like a wart. Do not weld to the scrolls. The existing gate is welded steel: a 16 mm square outer frame, two 12 mm inner uprights and 8 mm zigzag bars. On the inside face the inner uprights stand about 2 mm proud of the zigzags. Notch the bar about 2 mm where it crosses each inner upright, so it sits flat on every zigzag. Looking for 2 quote options please. See images for more details