Looking for an experienced handyman or plumber to disconnect an old dishwasher, install a new one, and move the old unit to the building's disposal area downstairs. Scope of Work: Disconnect & Move Old Unit: Disconnect the existing built-in Smeg dishwasher. Take it downstairs via the lift to the building's designated disposal/bulky waste area. (No vehicle disposal required—the waste room is located on the ground level right next to the lift). Prep Cavity & Cabinet Adjustments (if required): The replacement is a freestanding Midea 14-place unit (Model: MDW6065F14UX). Remove its top lid (standard 2 screws at back) to fit under the benchtop cavity. Remove any old fixing brackets from the cavity. Cabinetry check: Perform any minor adjustments if needed—such as trimming/notching the bottom kickboard to allow the new door to open fully, or slightly enlarging the hose hole through the cabinet partition. Install & Test: Slide in, level the adjustable legs, and connect to existing cold water, drainage, and power. Run a quick rinse test cycle to verify there are no leaks and that water drains smoothly. Site & Access Details: Location: Level 9 apartment, Sydney Olympic Park (lift access throughout). Please bring your own hand trolley/dolly and standard plumbing/handyman tools (including a multitool/hole saw just in case cabinet adjustment is needed). Old unit: Built-in Smeg (photos attached). Ready to book for the right person. Please confirm your availability when submitting your offer. Thanks!