Open

Assigned

Completed

IKEA PAX wardrobe assembly custom base, skirting and power cut-out

Posted by

Will O.

Location

Paddington NSW 2021, Australia

To be done on

Flexible

IKEA PAX wardrobe assembly custom base, skirting and power cut-out

$650

Details

I need an experienced carpenter or handyman to install an IKEA PAX wardrobe as a built-in-look unit. This is not a standard PAX assembly. It involves some carpentry, so please only quote if you’re comfortable with skirting work and building a simple timber base. The wardrobe: 2 PAX frames with sliding mirror doors, shelves, drawers and a clothes rail, going into a bedroom corner. Scope of work Remove the existing skirting where the wardrobe will sit. Please take care, as I’d like to reuse it if possible. Build a simple timber base for the wardrobe to sit on, levelled on packers. The timber is supplied and already cut to size. Assemble the PAX frames, interiors and sliding doors, and set the wardrobe on the base, flush against the walls. Fit new skirting to the front and the exposed side of the base, with a mitred corner, then fill and caulk. The skirting is supplied. Cut a hole in the left side panel for power. There’s a powerpoint low on the side wall that will end up behind the bottom of the left-hand frame. The hole lets a flat-plug power board plug in from inside the wardrobe, and the wardrobe should still sit flush against the wall. A grommet and the power board will be supplied. No electrical work is needed. Anchor the wardrobe to the wall, avoiding the area directly above the powerpoint. Clean up and take away the packaging. Supplied: all IKEA parts, cut timber, skirting, screws, grommet and the power board. Please bring: your own tools, including a mitre saw, hole saw and nail gun, plus adhesive, nails and filler.

0 new tasks
To see more tasks
or