20 Verandah Installation Tradesmen in Central Coast

Lightly do verandah..15min job, drill two holed and screw in two screws to secure a loose timber plank, pressure clean bacl courtyard 2.5 x 4.5..is pavers..pick the few weeds there...easy jobs.

Sheets need to be cut to size fixed and finished off with angle so I can paint over.

We have a two story home was initially built as a kit home the original verandah has been removed. need new one built full length house.timber

Paint roof, columns, and fasia on verandah, may need to be sanded and filles. Paint around roof line of 2 garages. We can supply the paint if easier, maybe take 2 days

My father’s mobile home in a retirement village on the Central Coast has a rotting steel girder under the front of the verandah. We need to have this replaced. It measures roughly 4cm x 6cm in girth and runs around 3 sides - 1 side = 1.5 Mts, 2 = 6.3 m and 3 = 3.3m No 2 definitely needs replacing. No 1 and 3 are potential replacements. Each section has a t-bar like support piece that sits on a timber post in the ground. This t- like section measures approx 8 x 6 cm Also need a carpenter to replace some rotting timber cross pieces beneath the verandah railing and the lower bar of the railing. Some cross pieces need replacing, some need repairing - the measurements are the same as 1-3 above. Photos are available. I’m making the enquires for my father - I’m giving his phone number.

we have a second floor verandah that needs cleaning. Includes all posts, eves and ceilings

Paint eaves of verandah, involves puttying drill,audio speaker holes and cleaning spider webs. About 12-15m worth.

Complete a half finished verandah tiling job. some tile cutting required. approx 2mtr x 1.5 mtr area. Have tiles and grout etc

verandah is on 2nd floor beam is approx 20m by 150mm existing paint is in good condition scaffold is in place for this week only I have the paint

Would like roof dismounted and taken away. 6x5 metres. 4 roof trusses, 2 fibro poles and colourbond roof

Verandah has had dry rot and requires some timber work and retiling

To fix the corner post of elevated back verandah Basically the verandah sits on giant joists with verandah roof corner post being bolted on to the end of joist. But the corner joist end has rotted and roof post has come loose and dropped a few feet, with roof corner only being held up by the downpipe (perhaps). One plan is to cut away rotted end of joist, brace with good timber, then jack up the corner post and reattach it to sound timber). Plus lattice rails can be reattached once this is done. This is at the most a half day job for 2 guys or owner can help one guy complete it, and has some tools. Prefer someone with carpentry/deck repair experience.

I need the verandah extended from the exicting one. I have purchases all the roof sheets.