Find experienced local tradies in Melbourne City CBD

Repair or replace awning for a cafe. Ground floor, easy access. Photos available

Looking quote on cost to do landscaping and front fence with brickwork and gate .

Recover fixed awnings in striped canvas

Hi looking for a qoute for bir x 1 and sliding doors made for another. Need measure and qoute

Electric Awning Installation. 1 day - Due date: Flexible - Due date: Flexible

Two planter bed render walls need deep cleaning and re painting. All paint to be provided. Roughly 10m x 1m each on 2 balconies. All paint provided. - Due date: Flexible

I am after someone to apply Dulux Texture Medium Coverage Paint to a 4m wide x 4.4m high exterior blockwork Wall. I have already cleaned & primed the wall. The paint will be supplied & will need to be applied using a lambs wool mitt. One coat only.

Need a built in wardrobe for one bedroom Apartment building in Melbourne city - Due date: Before Sunday, 29 October 2023

There are two areas that have wall adhesive hook removal damage to the drywall that need to be repaired and painted: 1. Minor paint chip measuring approximately 1.5cm x 1.5cm 2. Four paint chips, that may have taken off a layer of the drywall itself, total area approximately 11cm x 8cm. We have colour matched paint on hand. Looking for spot painting only. LOCATION Melbourne 3000 PARKING on-street parking - Due date: Flexible

Hi, We’re looking for a tradesperson experienced in plastering / drywall installation to affix Some drywall to an existing wall that has had some damaged gyprock sections removed, resulting in finished paintable wall. (Topcoat etc, Seams should be blended etc.) 16mm Gyprock sheets and all supplies (base coat, top coat, tapes) available on site. Section you see in the photo is 5m wide. Parking available on site. 9am start for a full day. - Due date: Before Friday, 8 September 2023

Drywall paper has peeled on the bedroom ceiling due to using tape that was a bit too sticky. Damage is three patches of around 10cm x 3cm. Need it to look better for an inspection. We don't have matching paint yet. Note that it's a regular inspection which is pretty casual so it doesn't need to be perfect, just not glaringly obvious. - Due date: Needs to be done on Tuesday, 5 September 2023

Need timber frame built straight on to existing walls and floor. L shape - on 2 walls (approx 4 meters each wall) 70cm deep and 1 end panel. External plaster finish and paint.

Render to front facade around 20m2 - Due date: Flexible

Patch dry wall 8cm diameter and paint hole in apartment, around knee to waist high. - Due date: Flexible

I am looking for a Carpenter to install a retractable outdoor awning on a balcony. Firstly I need a 3 metre length of 4x2 attached to the outer wall. You will need to find studs as it is a timber frame with concrete sheet and probably use Dynabooks to secure it as a base. The bearer then needs to be silicon sealed and then painted (I'll provide the paint and sealant etc). Then the awning cartridge, 3M long, needs to be attached to the 4x2 bearer. The installation is on the balcony of an apartment in Collins St. The balcony is 4 M wide x 2 M deep. The installation is approximately 2 M high on the entry side, so you'll need a ladder, and I can be here to assist. - Due date: Flexible

Renovations require a carport and garage built by tradesman carpenter from concept plan. Just a rough estimate, of time would be great. I think about 4/5 days work. Also the possibility of some demo work, removing the existing carport and verandah, if you have a good labourer. Labour only. Materials supplied. Possibility for ongoing work. - Due date: Needs to be done on Monday, 29 May 2023

Need to fix damaged awning in Melbourne CBD at little Lonsdale street - Due date: Flexible

Repair an indented drywall. - Due date: As soon as possible

Need to fix damaged awning in Melbourne CBD on little Lonsdale street - Due date: Flexible

We had a flood unfortunately and our ceiling drained until water flushed through... I post all pictures available. All pictures are about the same hole...