Find a professional balustrading contractor in Adelaide

Install 5.5m glass balustrade I will provide the 5 panels and 10 bottom plates/bolts which you need to drill into the concrete to industry standard

Stainless steel balustrade sourced and installed

Increasing height of balcony balustrade by approximately 30cm. Current height 90cm. Around 18 posts 50x50x300mm to be welded to current rails. Top rail 50x25mm to be welded to posts - Due date: Before Wednesday, 13 December 2023

I need two balustrade replaced on the back deck - Due date: Before Friday, 10 November 2023

existing balustrade is wobbly - Due date: Before Monday, 18 September 2023

My sister in Wattle park needs metal balustrade painted. Must be completed 30 May. At front of house. This is to quote on task asap. Only interested if it can be completed (quote and paint) by that time. You can discuss quote with her. She had it done before and painter did BAD job. My sisters says this “One banister has been sanded and one not. Length of balustray has been sanded. Two posts have been part painted - need sanded and painted (tall pipe in same photo doesn't need done. “ Basically she was trying to do herself but you can see it didn’t get done”

need a Carpenter to replace rot timber for level one balustrade - Due date: Flexible

I currently have 2 ‘turned’ stair posts that I wish to build over to create Hampton-style posts. ( please disregard budget listed as I’m uncertain how much this task should cost) - Due date: Flexible

We need a wooden balustrade building, the stairs are already in. It will need to be seen to be quoted for. - Due date: Flexible

I have 27m of steel balustrade that needs to be sanded back under coated and then painted in a satin black finish Will require wore brushing in some areas with surface rust etc Some sections are attached and some are not can be done on bench. Required to supply tools and paint. Ladders as required

Affix stainless steel wires to already installed and pre drilled timber posts. Total 12 posts, 26 linear metres of balustrade x 11 runs = 286m of wire. Have ordered DIY 3.2mm wire and 66 Jaw Jaw rigging kits from Scrooz. You will need wire cutters and a swaging tool to compress the ferrule and complete the swage. Ideally the person doing the work will be experienced and therefore have these tools. Please describe any prior experience when responding. Need it done before mid October, not fussed when. Budget is negotiable if more hours are needed to complete the task.