Find a professional awning contractor in Inner South Melbourne

Need to install my kings 270 free standing awning onto my kings tub rack on my Navara.

I have purchased 5 meters of awning to go over my balcony area that leaks. This is a temporary measure to stop water ingress and damage. The wall is some sort of metallic cladding that it needs to be attached to.

Install an outdoor awning to a brick wall. 1mx3m. Awning has already been assembled, just need it installed.

Hello sadly other installer fallen sick:( would you have availability today? I can drive to installer.

Needing someone to install a Fiamma 45s awning on my 2001 Jayco Dove camper trailer. Awning can be supplied if required.

2 x awnings to be recovered in cotton canvas. Monument in colour. Or similiar. Both 3m wide. 2.1 drop.

I have a new awning to replace existing awning which is torn.

My awning needs replacing I have the new one to be installed.

I have an electrical awning that is operated by a remote control. The awning will not open anymore, it’s making the constant sound like it’s trying to open but it seems to be stuck for some reason.

Electrical awning not working. Have changed battery in remote control but still doesn't work.

Our retractable awning has broken out from the brick, because it was left fully extended in high wind. The job is to drill out the hole bigger to install a thicker anchor bolt. Highett

I have a roof top tent and awning that will need to be attached to the top of my car. My car is a ford ranger with a canopy and base plate attached so it is ready to go! I have the awning attachment set also. 2 person job! Thursday evening after 4pm would be great timing if anyone is available!

Assembling and installing outdoor awning to the back patio. The wall is rendered and doesn’t have a completely flat surface (because of the texture of the render) -

Apartment Balcony - Awnings/shed installation * Install manual retractable awnings Length - 3400 mm Width - 1500 mm * Acrylic fibre fabric preferred

I need my 270 degree awning removed from my van and my new 2.5 x 2.5 awning installed on my van

I have purchased and assembled the Windoware awning from Bunnings. It is assembled. I am having trouble using my hammer drill to drill into the bricks and need someone with a better drill to come and help. 14mm drill bit. The job is installing the brackets (four holes into brick and fixing the brackets) and then fitting the blind is literally lifting it into the bracket and fastening the bolts. I’ve attached photos of the instructions and the assembled blind so you know what you’re working with - Due date: Flexible

4m (50kg) awning to be installed via four brackets each with two 100mm anchor bolts. So eight 100 x 16mm holes to drill into brick; I have a new 16mm Sutton mortar drill bit. Then lift awning into place - I can help with this. I have two ladders too. Holes measured and pilot holes drilled already. - Due date: Flexible

Carpenteer dissappeared mid job. All materials already onsite. To do: Contruct matching door awning as left side door in photo onto the right side door in photos. Install sall section of gutter and connect downpipe (the section between the two doors in photos. - Due date: Flexible

Very old window awnings x 2, hard to unscrew as screws are rusted. Need a strong drill. Please refer to photo. - Due date: Needs to be done on Friday, 17 November 2023

Awning window won’t shut properly and leaves a gap when fully wound. It seems to be on an incorrect angle. Need someone to problem solve and repair. - Due date: Flexible