Weld wrought iron gate.

Posted by Gary A.


Northmead, New South Wales, Australia

View map
Due date
Thursday, 31st Aug 2017
Need to source and weld 4 spikes/posts to bottom of old wrought iron gate where an angle grinder was used to remove it previously. Posts will be concreted in the ground when the gate is installed so appearance is unimportant. The gate metal is approximately 5/8 inches square in profile.
Darren B.
96%Completion rate

The percentage of accepted tasks this Tasker has completed.

I will source replacements and weld them on if you pay for the material. How high do you require the gate to sit above the ground? I can see the remaining posts in the picture but how much of those existing posts will be above ground? This will determine what material I can use and how strong the new posts will be.
1 year ago
Task Activity
3 comments about this Task
Comments are now closed
0 new tasks