Open
Expired

Attach a chin up bar to a brick wall

Posted by Kierin D.

Location

Queens Park, NSW

View map
Due date
Sunday, 2nd Jun 2013
Details
I need someone to attach 2 brackets with 8 dynabolts to a rendered brick wall. The brackets are for a chin up bar and need to support 100kgs+

The bolts will need to be provided, and can be added to the cost of the job.

One existing dynabolt may need to be removed.

There are existing hols for four of the bolts.
Offers
George C.
(23)
100%Completion rate

The percentage of accepted tasks this Tasker has completed.

Gregory T.
(60)
96%Completion rate

The percentage of accepted tasks this Tasker has completed.

Greg "the handyman" W.
New!
No Completion rate

The percentage of accepted tasks this Tasker has completed.

S V.
(42)
97%Completion rate

The percentage of accepted tasks this Tasker has completed.

Task Activity
6 comments about this Task
Comments are now closed
Still looking at doing this mate?
Kierin D.poster
Existing holes were drilled for 10 mm dynabolts. This is the size (10 mm x 75mm) that came with the bar.

I think new holes will have to be drilled and the old ones patched (the wall is rendered) as the alignment doesn't seem to be right and in addition the dynabolts come out of two of the holes easily.

So, likely to be 8 holes drilled, 2 dynabolts removed and some small patching. Patching will be additional
Thanks Greg.
I was actually referring to the 4 existing holes and what size would be needed for them.
8mm bolts will be more than enough as the weight will be distributed between 8 of them.
What size dynabolts?
0 new tasks