Open
Expired

3D printer repair (extruder)

Posted by Haydn P.

Location

Toowoomba QLD, Australia

View map
Due date
Thursday, 31st Aug 2017
Details
Davinci 1.0a extruder won't heat up, looks like it is a blown fuse on the main board that requires an external fuse soldered. Someone that has understanding of this kind of printer preferred.

Not sure if this is the issue so someone well versed in 3d repair is required.
Offers

No offers were made on this task.
Task Activity
5 comments about this Task
Comments are now closed
Does it show temperature at all for extruder? Does it change when temperature in the room changes?
Hi Haydn not offering to repair but where are you? Is it for personal use to you rent out your printer looking to find someone with one in Toowoomba
Hi Brodie, if you need a printer give us a call thanks! 04 triple 8 triple 3 double 8
you shouldnt need to solder anything
Haydn P.poster
Thanks Chris I did have a look at that they seem fine but I think it might need soldering I'm not sure.
if it wont heat up its to do with the heater carteridge, check for loose wires
0 new tasks