Find a professional hot water system contractor in Brunswick

*reposted after receiving the hot water unit Instant hot water unit install. Have brand new Rinnai B26 with bracket here. 3/4 inch feed to the existing unit. Removal of existing tank unit as pictured.

50 L Rheem Hot water system needs replacement. - Due date: Before Monday, 4 September 2023

Install plug in electric hot water system I will supply all materials and equipment connect inlet - Due date: Flexible

Hot water valve under the sink no longer working - won’t shut off water. Need this repaired. - Due date: Flexible

Replacement and installation of safety tray of my 50L electric hot water unit as a leak is causing the fuse to trip.

The gas hot water system has been off, I have tried to re-ignite it but can’t work what’s wrong - Due date: Needs to be done on Saturday, 13 August 2022

Require servicing to hot water system as water fluctuates from hot to cold in the shower. Water is hot and then every few minutes the temperature drops for a few seconds then goes hot again. I’m assuming the hot water system is at fault but not sure. Need someone to check and fix. - Due date: Flexible

Our hot water service needs to be fixed. Our showers are lukewarm and it takes ages to heat up. We had someone fiddle with the settings a few days ago but it hasn't made a difference. Sometimes the burner works, sometimes it doesn't. I'm in Brunswick. Offer is just for someone to come and look, and to quote us for fixing. We'd love it to be done this week if possible.

Hello We have a leaking metal roof where our internal hot water tank is underneath. Holes have begun to form from rust where water must've been sitting, around the base of the hot water unit exhaust flue. This advertisement is to supply & install the following: 1. New flue, at least 80cm long (about 40cm above roof) with cowl (rain cap) on top. My husband will cut the roof section out with an angle grinder (about 0.5m squared), keeping the flue in tact and remove the whole assembly, ready for the airtasker. 2. New section of roof cut to size & made water tight. For the new flue to run through. This can be done any time this week, but the earlier the better. Thanks

I have Rheem Hot water system fairly new but it only allows hot water for 5m ? Please advise what needs to be done - thanks - Due date: Flexible

Hi! Looking for someone who can supply and install a new hot water system. Would require PVR installation also (please see photos). Currently gas continuous (Bosch Hydro 16H) but we are open for other options too. Thank you!

Hi, in need of a plumber who can fix the hot water

My home is located in Brunswick near Barkley Square Shopping Center and we have a an existing Chromagen Eternity T26 Instant hot water system to be replaced with a new Chromagen Eternity M20 instant hot water system (The connection points are the same) and do a test to make sure it is working. I can be available during day, afternoon or evening and I will require a tax invoice

We have a 50-litre electric hot water tank that we would like to move slights (about 50cm to the right). We also have wall mounted taps and faucet in the kitchen that we would like to move to a counter mount. The copper pipes and sink are set into the brink. The tiles have been removed to the pipes are exposed. The cabinet around the hot water heater has also been removed. The building is double brick, ground flor apartment. If you could come quote that would be great. Thanks.

Supply & install new 50L hot water system

The cold taps around my apartment are all still running. However when I turn all the hot taps, no water comes out. I'm not sure exactly what the problem is, but I'd like someone to fix it.