Find a professional gate installation in ACT

Aluminium slat gate installation required. 3m(length) 1.8(height). Single gate. Slat colour- Monument

Construct a double garden gate (two gates closing on each other), each gate approximately 1.585 meter high and 0.88 m wide. They should consist of good quality timber boards, rounded at the top, and attached to a suitable timber or steel frame. The gates should have a keyed lock, preferably a Lockwood brand. The gates need to be installed, and attached to a brick garden wall on either side.

We have a few handyman jobs we need help with. Firstly, we need to cover the gaps in our wooden front gate so our dog can’t see out between the slats or underneath (we assume the easiest way is to attach large, thin piece/s of marine plywood or cement sheeting to the back of the gate, which will need to be supplied and painted — we have the matching paint — but open to suggestions). We also need to fill a gap between two outdoor walls so our dog can’t see out (gap is 70cm high x 19.5cm wide)— open to suggestions on cheapest way to do this. I’ve provided photos of both gaps. Secondly, we need approx 8 pieces of art hung on brick walls — we don’t have hanging materials so all will need to be supplied.

Installation of double gate. Colorbond. Thanks

Gate has broken from the hinge need to cut hinge off and replace with hinge as a medium term fix

Attach a new gate latch to colour bond fence & gate. (Gate latch has been purchased)

On behalf of my son who works full time. I am just putting $200 into the budget as I am not sure on a cost. Electric water heater in third floor flat (no lift). All three sinks in flat receive instant hot water but the shower only heats up if a tap is run and then shower water flows warm only for a short time. No handyman or unregistered trade please, Plumber or heating engineer with warrantied work only. Thank you kindly. :)

Hinge needs replacing on gate

Two gates need some minor repairs so they open smoothly. It may need some shaving off the bottom.

Need a front chain wired fence approximately 24 metres long and also need 2 gates

One Carport gate needs to be reattached to its support (bolted front to back). The welding on metal frame of the timber gate has rusted out causing gate to lean. 2 x Gal brackets to be bolted to hold frame together and one corner bracket at lower edge of the frame. - Due date: Flexible

Iron gate brick anchor bolts come loose. If 2 person job the will help, labour wise.

The glass fence (for a pool) is already in place. Just need a glass gate put in to replace the white metal gate. We can remove the white gate if that is easier? The width is about 1m. Can pay for materials - Due date: Flexible

I have a colourbond gate that needs securing so that it can be locked from both the inside and outside.

Aluminium slat fencing Approximate 2700mm X 1800mm high 1Xsgl gate with lock latch deluxe 65mm x 16mm slats horizontally spaced 10mm supplied and install 1m x 1800 hardwood paling fence

I bought a pet gate to keep my dog out of the corridor but it's beyond my limited skills to install.

Need someone to put up a retractable dog gate on a door frame (wooden). You'll need to have your own tools.

My glass pool gate has dropped so that it now drags along the garden border. I need it adjusted back to its original height. The rubbers on the closure/lock mechanism (pictured) have started to degrade so the lock is slipping on and off. It needs adjusting also. - Due date: Flexible

Install timber gate in front side external wall, to span about 130cm from wall to planter. Put in a MDF panel in gap above oven. - Due date: Before Sunday, 4 February 2024

I need a balcony door handle latch receiver moved slightly upward to align with the lock on the door / door handle. There is a slight misalignment (about 0.25cm) that has occurred over the years, so it does not close properly. Separately, I also need the latch on a gate fixed in place, there is a small piece of wood holding it at the moment. - Due date: Before Sunday, 12 November 2023