Find professional metal gate repairs in Outer East Melbourne

Grind and weld gate located at front of house

Metal gate needs to be cut in three places to shorten then re weld gates do not close correctly and there is no adjustment at hinge side so the square tubes need to be shortened by approximately 15 mm the Re weld. No need to worry about paint. - Due date: Before Tuesday, 19 December 2023

Please install a gate suspension spring on a metal gate. Gate is all metal base. I will need assistance in buying the right type of spring coil for my gate. See images attached. Quick and easy job. - Due date: Needs to be done on Saturday, 21 October 2023

I have purchased a single heavy metal gate which I would like to place in the opening as per the attached photos. The openig is 1620mm wide and 2400mm height. The gate is 1388mm wide and 2215mm height. We require a metal worker to fabricate a suitable heavy duty metal frame for the door which covers the opening. The door opens inwards left to right. Need a professional to come onsite and provide a quote for the job, including material to be used and design. - Due date: Before Sunday, 22 January 2023

Paint metal gate with metal palings, and a spear top, 1.6 m x 1.8m. 1 coat only needed, I have paint and brushes. - Due date: Flexible

Need two double metal gates replaced. They are currently sagging/ damaged. Etc One is ~5.2m wide and 1.5m high. Second is 4.3m wide and 1.2 high. Pictures below. One is attached to brick wall. The second to a metal post. (This post is currently loose and needs a new one out in.

Outdoor gate hinges rusted and the screws are no longer able to screw the gate on to the pole. Need to de-rust hinge or replace the hinge, so that the gate can connect back to the pole. - Due date: Flexible

Gate hinge needing replacement. I have attached a photo of the broken hinge and one of the other hinge. The gate swings inwards and goes on a diagonal upward angle when opening

I need someone to weld a latch to my gate to make it secure and lockable. Weld doesn’t need to look perfect but needs to be strong. I will purchase latch.

Fix side metal gate not closing. It needs about 1 to 2cm adjustment as its hitting on the top corner and hard to close.

I have a metal entrance gate. Two bars were damaged ... one bent and the other bent with the bottom weld fractured. Job is to take the bends out (as much as possible) and rejoin the bar with the broken weld. Pictures attached. Note there is no electrical power nearby ... gas job. Want the job done before 5 November.