Find a local electronics repairer in Keilor East

Trees removal + stumps grinder

We require 4 holes and a rectangle to be cut in a 20mm stone benchtop. - Due date: Needs to be done on Tuesday, 23 January 2024

Need a carpenter to cut to measure a few pieces of 6mm thick plywood boards. 6 boards to be cut into 2 inch strips. And 7 pieces of other measurements. - Due date: Before Thursday, 18 January 2024

We need the basins and taps and also the splash back removed (very carefully as they are to be reinstated… except for tiles) so my stone mason can replace the stone bench. Need this done around the 11-12Jan Vanity is small 1600x500 easy Just basins and taps and tiles on walls THAT ALL please don’t ask if anything else is to be removed it’s clearly stated what’s coming out Refer to photo - Due date: Needs to be done on Thursday, 11 January 2024

I need my Yucca tree to be cut to the ground and remove the stump. I also have other previously cut trees to have their stumps removed from the ground. Would like the green waste taken with you also - Due date: Before Saturday, 13 January 2024

I need my Yucca tree to be cut to the ground and remove the stump. I also have other previously cut trees to have their stumps removed from the ground. Would like the green waste taken with you also - Due date: Flexible

2 bathroom sink taps and kitchen sink tap. Also new toilet bowl replacement - Due date: Flexible

I have replaced the headband on a pair of marshal major headphones and do not have the soldering abilities to solder all the wires my self back on. - Due date: Flexible

Just need someone to cut back dead tree stumps to behind my fence line. Need a decent chansaw - Due date: Before Thursday, 20 July 2023

I restumping 1 or 2 stumps replaced . - Due date: Flexible

I need two taps to be replaced. Can buy the taps but need assistance with install. - Due date: Flexible

Replacing current kitchen and toilet taps - Due date: Needs to be done on Thursday, 10 November 2022

Needing an experienced electrician to fix my GHD. My straightener will turn on, heat up and I can use it for a 2-4mins but then it starts to flashing red and beeping. I believe this is due to a intermittent power fault cause by an problem with power cable or with the power cable connector inside.

Truck needing jumpstart on Tuesday 19/4/22 My medium rigid flatbed truck has had two new batteries installed just under one year ago however due to myself being in hospital batteries have gone flat. This is a simple task. Just need someone to jumpstart truck with good quality jumperleads and experience. Should not take more than 5 minutes to do. Preferably someone with mechanical experience and equipment. This job needs to be completed on today Tuesday 19/4/22 anytime from 12pm onwards. Flexible on time

Need 20mm benchtops granite or stone (whatever is cheaper) supplied and installed. See attached pic. Island 1.5 m x 650mm Then length across the sink is roughly 3.5m Then from oven is 3m roughly Then the opposite side runs roughly 1.7 m Update: there is a waterfall at island bench. The current length of benchtop template needs to be reduced as it’s currently sticking out too much.

Kitchen sink taps and faucet need to be replaced, bath tub faucet needs to be replaced, outside tap needs new seal (or new tap), 4 other taps need new washers - Due date: Flexible

Out door steps from path to front door similar to picture 1. Happy to be advised on what would work best. I have put some suggestion pictures in such as wooden painted steps with concrete on top. Lights to be put under each step. - Due date: ASAP

I need to get 2 small tree stumps of similar sizes in a trench removed either with a small stump grinder or any other possible way. Have attached photos with measurements of stumps.

I have a front verandah/porch (cemen) which is about 4.2 metres long and approximately 1.2 metres wide that I would like it tiled. I have the tiles already. Fiona

It seems the output on my Yamaha amp is not working. It’s connected to my epson projector. The sound is working but the picture is not.