Find trusted local electricians in Frankston South

Initial assessment is required to review the space and ensure best solution, free quote appreciated before works are done. Ultimately after a qualified electrician who can install 2 disco ball motors and 40cm disco balls to existing light fittings, includes remove existing fitting and connecting the disco ball motor to power source so light switch makes it turn on and off. Don’t want new drill holes in the cedar roof. Ceilings are tall and sloped ..:approx 14ft tall. Ive been advised that this should be a quick and straight forward task for any qualified electrician, so after a reasonable rate. https://djcity.com.au/product/brightlight-lmm-40-mirror-ball-motor/ https://djcity.com.au/product/brightlight-lmb16-16-inch-mirror-ball/

Resituating a power point and fixing two down lights that aren’t working.

Need to replace 11 down lights, Wire and Intall 11 down lights Replace 2 external wall lights Wire and install 2 external lights Wire and install 2 exhaust fans Relocate 3 switches Replace GPO 24 - Due date: Before Saturday, 3 February 2024

Need to install 20 downlights - Due date: Flexible

My Rinnai infinity 26 is not heating to 50 degrees anymore . It is still heating but not at the temperature it used to be. Hopefully it just needs adjustment or small part - Due date: Before Friday, 22 December 2023

Need 6 power point replaced as they are old and damaged. Would like them replaced with similar ones to the image - Due date: Flexible

Install split system aircon 2.6kw system. Haven't purchased yet, happy to buy through you, otherwise this will be the unit: https://www.kogan.com/au/buy/kogan-smarterhometm-26kw-inverter-split-system-air-conditioner-reverse-cycle-kogan/ The outdoor unit would most likely need to be installed on the roof. There's two other air con units that are in rooms down the hallway (not sure if you can use the same circuit as them?). We currently have 3 units in the house. 1 larger in the front and 2 smaller in the back. The 2 smaller ones run on the same circuit, I *think* the front one runs on it's own. Indoor unit will go on either wall that doesn't have the window on it. Picture of roof and outside of window attached + switch board. There is *approx* 5m from the room to the switchboard. Please quote for labor component, and unit if you're able to provide the unit as well. The unit should be a smart one that can be controlled over wifi. - Due date: Flexible

I have 4 down lights that look like transformers have gone. Supply and replace needed. - Due date: Before Friday, 8 September 2023

I just fitted a new motor to a dough mixer and need the power cables connected. I also want the mixer tested and tagged. - Due date: Flexible

Electric recliner chair has stopped working. The footrest is partially out and cannot be moved. The green light on the side of the recliner is showing green, but nothing moves. It stopped instantly with out any warning - Due date: Flexible

My Electrolux condenser dryer needs the drive belt replaced. It’s heating but not spinning and has been diagnosed over the phone with Electrolux. Need belt supplied and replaced Flexible with when it can happen thought I’d opt for a cashie to help someone out with some work rather than use Electrolux - Due date: Flexible

Intercom system covering front door and and kitchen/family room plus a few other rooms. Most important task is to have the door bell to work! - Due date: Flexible

Disconnect old freestanding dual fuel stove and connect new one. A swap over same size - Due date: Before Thursday, 19 January 2023

Lead in conduit kinked during excavation of tree stump/root.Conduit requires repair and cable needs repair or replace. Need to make sure NBN is working afterwards. - Due date: Needs to be done on Monday, 7 November 2022

Installation 4 power points - Due date: Before Friday, 4 November 2022

Replace five fluro lights with warm white down lights x five Replace existing fan with new one - Due date: Before Thursday, 3 November 2022

Bike fell off a bike rack and has jammed up - Due date: Flexible

Approx 15 M of Modular walls (at 1500mmh), posts at 1600mm high (I will paint these) Electric sliding gate - 3.3m x 1600 mm H - will need footing and track installed. Electrical to gate motor if possible. I will purchase all components - but be ideal if proposed order can be checked after site visit. Ideally you have installed a modular wall system and an electric sliding gate before. - Due date: Needs to be done on Wednesday, 23rd Feb 2022

We need two outside sockets put next to air-conditioning unit where pool pump is going to be placed.

Wall light on ensuit. Live cable looped out of wall currently not safe Provisions already there at switch