Find trusted local electricians in Cromer

Outdoor light Main board circuit work One indoor light Smoke detector

Split air conditioning need to be installed back to back but out side unit needs to be installed on the wall - Due date: Flexible

Need Electrical work to be done on boat Power up the head unit and amplifyer - Due date: Needs to be done on Wednesday, 29 November 2023

Bosch Classic dishwasher. 8 years old. Water does not heat up. I have checked the circuit board and there is nothing burnt out. - Due date: Flexible

Hi, My electric wall oven stopped working suddenly. The grill is still working fine. I'm looking for someone who could repair it. Many thanks, Bruno

I need a licensed NBN electrician to move an NBN port up around a metre so it is hidden behind the TV. - Due date: Flexible

Lamp light will not turn on. Have replaced the bulb and problem still occurs. - Due date: Flexible

Rear view camera and brakesafe system not working on caravan - Due date: Before Monday, 25 April 2022

I need a power point installed in a cupboard. You will need around 2 meters of conduit to run from the other closest power point see picture attached.

Solar power stopped registering on my power bill. Energy Australia not interested , Soltek doesn't answer the phone. I have turmed a knob and flicked a switch, but not sure what is happening

Looking to: - add another double GPO behind existing hung tv - relocate an existing antenna socket behind an existing wall hung tv. - Also wanting to add another double GPO down below. Can run down the same cavity and terminate lower down. - run existing speaker cables in wall cavity and terminate

I need to move the indoor unit of my split system airconditioner a meter higher

I've pulled the plate away from the wall when removing an appliance plug.

I have moved into a two story (ground and first floor) brick veneer house in Cromer NSW 2099. There seems to be a new digital antenna on the roof, but no reception located at room points. Job 1: Relocate antenna from the south eastern corner to the south western corner of the house for aesthetic reasons (see attached pic). Job 2: Make sure TV signal is active at relevant points (living room, entertainment room, bedroom) and run cable to add an extra point to Computer room (which is on the ground floor, directly below where the TV antenna will be mounted). … NBN Job 3: I have a good 250Mbps HFC NBN connection. It runs from the pole in the street, to a box on the outside of my wall, to the upstairs study. I would like to change the last part to run it from the box to the downstairs Computer room (directly underneath the study). … Data cabling Job 4: I want to run a Cat6e ethernet cable between the computer room and the living room, and a second one between the computer room and the entertainment room, to take pressure off the WiFi. ... Job will likely require some patching when running cables behind the gyprock. ... Timing: Times that suit include: Friday 14/05/21, or by mutual arrangement. Cheers OB

Our Electrolux Front Loader is showing an E20 message and the machine is struggling to completely drain. In the past I have cleared the drain and it has been aok however am unable to do this myself this time. It would also be good to have the seal around the door replaced. The model is an EFW12832. ideally the job will be completed in before noon of 30 March 2021 (tomorrow). Message me for further information.

Wire in replacement bathroom fan with heat lamps, wiring and unit in Position Swap over of Hunter Pasific light fan combo as broken, spiggot that attaches light to fan motor has broken motor is working

Have bought new place in Cromer, NSW. Getting it painted this weekend. Have removed furniture to find cables protruding from wall. Need cables to be either safely cut/removed or put through to appropriate wall bracket.

The electrician wired up everything before tiling but he does not have time to finish it off now after tiling. There is a double switch and a triple switch. Two switches on the triple one are paired with the two on the double switch. All you need to do is to connect the switches. That is a type of a job to do on your way back home before celebrating the new year ;)

Hi, Looking for electrician to connect my cooktop to the power. Gas will be connected so just need to connected to power Must be this Wednesday Cromer Photos attached First photo- current cooktop Second photo _ already removed and there is power available to connect to new cook top.

What required is in two steps. This task is for the first one. We have to arrange the second part later separately. Next week someone will demolish and redo the driveway and I like to have lights on both sides of the new driveway. There is a light on top of the driveway (check photos) with its switch at the bottom on the wall. It is one opportunity to take wires out and get them ready to pull underneath the new driveway. The switchboard is close to that switch, on the other side of the wall, with its photo attached. What required is in two steps 1. Come in and get things ready before the driveway builders start 2. Show up on the concreting day to ensure things are done correctly I prefer you to be local so you can guarantee showing up promptly. The start day for the driveway is not set in stone but it will from 10-12 Dec.