Find an experienced concreter in Frankston

We have 3 storm water drain grates that need to be fixed.

Need someone to; Concrete & dig in 15 x sleepers. Image attached. Cost must include supply of sleepers 2400mm x 15 - Due date: Flexible

To cut out a piece of stamped concrete driveway 3 meters x 2 meters x 50 mm deep and remove concrete. It is a small job and maybe too far away for you?

Concrete driveway and side of the house - Due date: Flexible

Concrete block, approx 140 ml thick, 1100 x 2900, had a shed sitting on it, requires jackhammering - Due date: Flexible

Removal of approx 8 sq. metres of concrete, approx 100mm thick. It will be pre cut into 500mm square pieces this week. Will probably need a bobcat for easy removal. Good access at side of house. - Due date: Before Tuesday, 11 April 2023

2 steel poles concreted into driveway. Concrete driveway to be cut out, dig hole and cement in - Due date: Flexible

Resurfacing of existing driveway with lilydale topping. Weeds are coming through ans I require a solution for this. I do not want it concrete but if you have an alternative solution please let me know. Apprx 10-12m of driveway x approx 3.5m wide. - Due date: Flexible

Need to cut the last metre off my brick fence. Probably use a concrete cutter - Due date: Before Sunday, 27 November 2022

Relocate 150 retaining wall blocks from Frankston to Vermont. - Due date: Needs to be done on Saturday, 14 May 2022

Concrete and easy drain need assistance - Due date: Flexible

Hi I’m looking for a quote for our driveway

Hi all, After a handy man to cut up and remove a 1.6mt by 2.3mt concrete slab in my backyard. Quote including concrete removal from property if possible please. Cheers Josh

Exposed Aggregate concreting very close my driway, nearly 6 squire meter - Due date: Flexible

setup plain concrete driveway and crossing remove existing crossing

We need 2 strips of concrete cut for a trench to run conduit for electrical wiring First trench is approximately 8m long by 50 mm Second is approximately 2 m

Make an offer. I have an area of approx 6.2m x 6.5m. The house on 3 sides, last side open. It has mixed types of concrete with level up to 70mm off level. I want to have it resurfaced with plain concrete.

Howdy I need 36 bars made for a bee hive Each bar is 10mm thick 40mm wide 420 mm long On top of each bar is a spline This can be made in many ways The bar and spline in one piece would be best The spline must be in the complete center of the bar I have attached pictures for help I would also like 4 holes the same as in the picture

I need approx 2m2 of an old paving concrete to be jackhammered or cut then removed from site. The section is only around 80mm thick and doesn’t appear to have any steel in it. You’ll require a jackhammer or concrete saw to break it. I’ll also require these bit of concrete along with some other old pavers (approx 25) to be removed from site. The pavers will be loose and stacked to they will be easy to be loaded and moved.

We recently just ripped up old floor and just need the existing grout/ concrete grinding back, pretty much just a once over on the concrete to level it out for flooring. 35sqm area