Find experienced local carpenters in Melbourne

my computer is not starting up

Cut part of two wooden shelves out of linen cupboard, and build a small space in the cut out section to hang coats

Currently we have a cupboard with two drawers inside of it. We’d like to replace it with a pull out bin as deep as the cavity. Will require a handy man to measure up, quote purchase supplies then install.

small studio room in my backyard. table inside the room which we can't take out. size is 2 m x 3m. need someone to put venyl sheet in the room floor. I also have adhesive to paste the sheet.

We’re putting quite a heavy bar top on at a restaurant. It’s a DIY job. We want a carpenter to have a look and check our work suggest any improvements and potentially give us a hand to make improvements

The steps to my house are too steep for my 80 year old mother. Need a handrail!

Looking for someone to extend a deck. The area is 4.03m x 68cms. However, need decking to cover 4.03m x 87cms to replace the edge board. Please include all materials - posts, joists and decking boards in your quote. Or separately estimate and we can reimburse. Current boards are treated pine (would like to match) and 88mm wide. Please also add one extra post to your quote. One of the current posts on the end needs to be replaced

Need a cabinet maker or carpenter to prepare one kitchen cabinet for a dishwasher installation Measurements of inside of cupboard are 66cm wide, 55cm deep, 68cm high

We need help to build two garden sheds

I bought this vanity desk and tried to assemble it myself and have not done a great job at all. Ultimately I’m stuck at the drawers and they have become jammed, I think I have broken the tracks. I need someone to come finish the job for me & maybe get new tracks for the drawers ? I will reimburse the fee for new tracks as a seperate cost. Sick of it being half finished in my room need someone to save it !!!

I have wire shelves in my pantry (as pictured). These are insufficient and I would like proper wooden shelves built into the pantry - wrapped around in a U shape (shorter on both sides) with enough room for appliances to be stored underneath and on the lowest shelf. Being an old house, there are a few tricky materials that would need to be supported (hope that makes sense!). The walk-in pantry is .92 x 1.52. I have had a series of tradespeople lined up to quote and then either fail to show up or cancel the work. I urgently need this work completed as this is the only storage I have in my place. (please excuse the haphazard mess as a result of these stupid shelves). Due date: Flexible

Help build a kitchen island cabinet. I have the parts, the screws and bolts for it.

I need this drawer removed as need an oven in that space and about 50mm short.

Place a door on exiting cabinetry to create a linen closet with an additional shelving unit. Form ply provided. Picture below door where the wine rack is currently and is to open upward. Plans and measurements below.

I have a outdoor dining table that is gray and needs to be prepped and stained to match the chairs and the legs of the table. Need help finding stain

Trim down a wood board height by approx 0.5cm New floorboard installation has pushed up a board, which causes dishwasher door to clash with the new board height.

inspect, provide advice and quote 4 carpenter tasks on a 100yo weatherboard house. 1) I have removed 2 rotten weather boards on my 100yo weatherboard house in Melbourne, then any visible rotten wood. See the results on the photos. I believe the wood needs to be repaired, reinforced or replaced. 4m long bearer. Put weatherboard back, ideally in a way that they can be taken down to access the crawling space easily in the future. 2) Fix the damaged weatherboard + 3.5 of skirting on the deck. It looks like there is more damage behind but could be saved. 3) Split bearer. Looks to hold up well. Not sure if this is a risk. Not heaps of crawling space so you need to be thin. 4) Joists and subfloor in the bathroom.

Stainless steel benchtop caulking needs replacing along all three edges. Looking for a high-quality caulker for Tuesday 19th of March. Thanks!

I need a rectangular size hole cut into my existing deck. Size is: 2630mm l x 400mm w. I will dispose of wood and tidy up space afterwards

quote 4 carpenter tasks on a 100yo weatherboard house. Keen for advise if each task needs a full remove and replace. 1) I have removed 2 rotten weather boards on my 100yo weatherboard house in Melbourne, then any visible rotten wood. See the results on the photos. I believe the wood needs to be repaired, reinforced or replaced. 4m long bearer. Put weatherboard back, ideally in a way that they can be taken down to access the crawling space easily in the future. 2) Fix the damaged weatherboard + 3.5 of skirting on the deck. It looks like there is more damage behind but could be saved. 3) Split bearer. Looks to hold up well. Not sure if this is a risk. Not heaps of crawling space so you need to be thin. 4) Joists and subfloor in the bathroom.