Find an experienced concreter in QLD

We need to make our side concrete path 25mm narrower to accommodate a new retaining wall. Looking for someone to make a single cut 10m long along the edge of the concrete path. Concrete does not need to be removed, we just need it cut so then we can break it up and remove it.

Had a plumbing leak which has been fixed. I now need a concreter to reinstate the sand tie ins and concrete Slab is approx 500mm x 500mm x 100mm

Cut and remove a concrete slab. 6mx6m x100mm thick with reinforcing. Access to site is through a carport 2.3m high.

Cut and remove excess slab around pool approx 6.5sqm, would like cut to be 100mm or less from pool edge, please see photos, thanks

Looking for someone ASAP this morning to cut concrete and jackhammer 2m of concrete for a toilet relocation. Saw and jackhammer supplied.

A shower grate drain, 900 x 100mm, needs to be installed in a concrete slab and this needs to be cut out. It also needs the drain to be continued so it can reach outside.

Looking to get 60sqm of a 150mm thick concrete driveway cut. I can arrange a concrete skip if required to assist in the disposal or happy for you to manage the disposal.

We have a downpipe that was not connected properly under the pool concreting and is leaking through the house brick wall. Need to cut away the concrete surrounding the downpipe so a plumber can then fix the pipe fitting.

2* 80cm cuts through 125mm concrete

cut existing concrete beside patio/fence • install channel drai • connect into existing backyard stormwater drainage • fix pooling water issueduring rain Have dug put piled dirt from the current drain which flows when the water hits the pipe level in that drain

I need someone with a concrete saw to cut through 2 or 3 concrete post foundations. Foundations are approximately 400mm × 200mm

One concrete cutting 6m long.

Concrete Slab: 3.8 m x 2.28 m need cutting up only.

I need to core a 150mm-200mm diameter hole in a reinforced concrete slab that is 100mm thick. The hole should be as close as possible to the fence sleeper. The purpose of the hole is to provide an opening to install and 50mm in-ground gate post. The surrounding concrete should not be damaged.

I am in need of getting a concrete cutting job done. need to cut or jack hammered this concrete footing to the ground level. around 13m in length. Open to hear the quotes.

Repair patches of spalling concrete along edge of slab. 2-3 metres. Repair rough edges of concrete slab about10 metres.

Concrete re surface and paint and cut drain hole

I need a hole cut in a 200mm block wall. It’s probably core filled. Hole must be big enough to fit a 90mm stormwater pipe though.

I have some old concrete that needs resurfacing/restoration. Approx 30 square meters. It is old and has had a layer of paint on it. I'm not too fussy on the options just want to freshen it up so it matches the rest of the house.

Need to cut a concrete driveway tomorrow 3m long, and 50mm wide, around 100mm deep.