Find experienced local carpenters in Rockingham WA

Looking for a tradie who is capable of drilling a hole into the commercial kitchen hoodrange in order to secure the oil tray as shown on the image

Details: 1. Measure the canopy floor • Measure the length and width at several points, as the walls may taper or include wheel-arch intrusions. • Note the locations of tie-down points, access doors, wiring, drain holes, and any raised sections. • Make a cardboard template before cutting the plywood. 2. Choose suitable materials • Use 12–18 mm exterior-grade or marine plywood. • Seal all plywood edges and faces with exterior paint, polyurethane, or marine varnish to protect against moisture. • Use stainless-steel or zinc-plated fasteners, washers, and brackets. • Add rubber matting, carpet, or closed-cell foam under the floor to reduce noise, prevent slipping, and protect the canopy base. 3. Cut and prepare the floor • Transfer the template to the plywood and cut it carefully. • Test-fit the panel before sealing it. • Sand the edges, then apply several coats of sealant, paying particular attention to cut edges and screw holes. • If the floor is large or difficult to remove, divide it into two or more sections with a small clearance gap between panels. 4. Install the plywood • Place the rubber mat or foam beneath the plywood. • Avoid drilling into the vehicle body unless necessary. Use existing canopy mounting points, factory tie-downs, rivnuts, or removable brackets where possible. • If drilling is unavoidable, check both sides of the panel first for wiring, fuel lines, brake lines, and structural members. Treat exposed metal edges against corrosion and seal all penetrations. • Use large washers or backing plates to spread the load.

Need to make an Oven cabinet in the kitchen.

Fit kaboodle cabinets to a laundry

Install two pre-assembled overhead cabinets side by side onto a tiled brick wall. Cabinets must be securely masonry-fixed, level, aligned and joined together. Please supply appropriate masonry fixings and use suitable tile-drilling equipment. The wall is above a laundry sink, so care must be taken regarding concealed plumbing and electrical services.

A purlin above the garage has a crack in it and needs supporting

We need to make the cabinet fot cafe

Looking for a skilled carpenter to help me create a hidden drawer inside a counter. The goal is to have it blend seamlessly, so no one can tell it's there. If you have experience with this kind of work, please reach out!

Dismantle brand new wooden shed structure. Removal of timber not required or you can make an offer.

Job is to provide quote for install. 2014 Fiat Scudo Rear internal floor, walls and roof to be lined to use as campervan. Materials will be supplied as required - must have own tools. Must be able to show proof of similar work. Ideal project for retiree or someone wanting to work on it evenings/weekends for some extra cash. Van has been thoroughly cleaned ready for install.

Build 3 shelves in existing cupboard and drill 5 nails for paintings. Cash. Rockingham. - Due date: Flexible