Find experienced local fencing contractors in SA

The 8 meter fence needs to be removed from the site.this is a task that needs to be done asap. We don't need the wood removed and no posts needs to be removed.. the fence is screwed and at some placed bolted as well...

I am replacing a 16.4m section of old fencing with a new fence. The new fence will have a 400mm high concrete plinth, 2100mm high x 2400mm wide colourbond fence panels, with a colourbond diamond lattice fence topper 600mm high x 2400mm wide. Total fence height is 3100mm. The fence posts will be concreted 700mm deep and extend to the top of the colourbond panel section as the fence topper has 600mm extension post sections which are bolted to the fence posts. I attach an image: 1. Existing fence which is 2100mm high (colourbond panel is 1800mm and diamond lattice is 300mm high). Essentially the new fence is a copy of the existing fence but higher by 1000mm. I also have available a Document which list council requirements for fences/retaining walls. I don't believe the full list is required but unsure. and a Site plan - the new fence is on the Eastern (left Hand Side Boundary) extending from the rear of the neighbour's garage to the corner of the rear fence (16.4 metres)

We are seeking a detailed quote asap for repairing the boundary fence on our commercial property, which spans from our building wall to the lane way. In your quote, please assume the two large gum trees that caused the damage to the boundary fence will be removed (see attached photos). The quote should include: *Removal of the current fence so it can be re-installed. *Removal and dumping of the existing concrete plinth and other debris. *All earthworks including cutting and removing the tree roots that have been lifting and damaging the fence. *Correct preparation and compacting for the new plinth. *A new level and straight concrete plinth to replace the current damaged plinth. Concrete should be min. 25 MPA and include galvanised mesh reinforcement. *Re-erecting the current fence including the signage onto the new plinth. (Note - steel posts will need to be replaced with equivalent size and quality posts.) *Leaving the site on both properties clean of all debris.

About 30m of brick wall/fence to be removed. 23m of the wall is besser block and a row of single red brick.7m is single red brick. The fence is about 2m high. On the inside is flat ground and there is an empty swimming pool 2-3m from the edge. The outside of the fence is a steep slope of 4m of 1:1 slope. Easy enough to stand and work from. This is manual labour. Or mini excavator work. Choice is yours. I will supply a skip bin for the bricks.

Hello, need a quote on getting fences installed, colour bond 1.8m high

I need a quote for installing brand new mesh wire fencing in my backyard. The existing one is damaged and needs to be removed and replaced. I can get the materials needed. It’s about 25 meters long

Build / supply and install gate approx 197cm high and approx 91cm wide. Inside pool safety zone to close off pump enclosure.

Install 4 black decorative panels to a fence line, 1.8meters high x 900 wide, i have the panels and the text screws

Replace 27meters of post and rail fence panels plus 1 post also needs replacing

3 side boundary fences need quoted and done Asap

Quote o4required for 12Replacement 73Side 91Gate and 92Fence, installation only. Standard Colourbond, 2m high, (not Good Neighbour).

I want to install tubular fence panel with swing gate. fence length is around 18m and swing gate 4m.

garden wood fence needing fixing and repaint. on the side, fence leaning towards neighbors， needing correct

Need someone with experience in fencing to help me out fixing a gate. It looks like it need some welding done and fews other little things. Even a handy man could probably help . Need it done urgently tomorrow morning .. Happy to meet directly

Need good trades do good neighbour fence $35 per hour Or give quotation

Hi - 30 years of ivy have caused this brick wall to start to collapse. We need the wall removed and made ready for a Stratco fence to be installed. This requires detaching it from the existing Colourbond fencing, pulling down the double brick 1.9m high, 21LM wall, removing the bricks and footing, and disposal. The brick letterbox wall in the photos is staying as is. Please don't hesitate to ask for any clarification that you may need. Thanks so much!

2 (maybe more) holes in base of fence, needs anchoring to ground

Looking for a carpenter or tradesmen to rebuild our wooden side gate, which is damaged. See amending photos. - Due date: Flexible

I have a 14.5m frontage that I would like a 1.4m high timber fence frame, with 2m centre studs and a timber battern gate for pedestrian entry. It would be approximately 13m of fence and 1.5m of gate, there or thereabouts. Looking for a hardwood construction, concreted into soil for most, but an existing concrete strip footing exists for approx 5m that can be used if preferred. Site visit would be required. - Due date: Flexible